Hummer H1 (2006+). Manual — part 187
4-28
Cooling System
__________________________________________________________
pressure grease gun, to the joint slowly until old grease can be seen exiting around the sleeve on the shaft. Wipe the excess grease
from the shaft when finished(Figure 4-25).
NOTE: It will be normal for some grease to exit the CV joint seals during engine operation, DO NOT replace the CV joints for this
condition.
Figure 4-24: GFD Fill and Drain Plugs
Removal
1.
Drain the engine coolant.
2.
Remove the front driveline protection.
3.
Remove the front axle assembly (See section 9).
4.
Remove the lower coolant pipe.
5.
Remove the four bolts securing the GFD drive flange to the harmonic balancer (Figure 4-26).
6.
Remove the four bolts securing the fan and viscous drive assembly to the GFD.
7.
Use “bungee cords” to support the fan assembly for GFD removal.
8.
Remove the four bolts securing the GFD to the cross member and remove the GFD.
FILL
PLUG
DRAIN
PLUG
GEARED
FAN DRIVE
11-1-05
_________________________________________________________
Cooling System 4-29
5745804
Figure 4-25: Coupler Shaft Grease Points
Installation
1.
Install the GFD in the cross member and secure with four bolts and torque to 44 lb ft (60 N•m).
2.
Secure the fan and viscous drive assembly to the GFD with four bolts and torque to 80-100 lb ft (108-135 N•m).
3.
Secure the GFD drive flange to the harmonic balancer and torque the bolts to 44 lb ft (60 N•m).
4.
Install the lower coolant pipe.
5.
Install the front axle assembly.
6.
Install the front driveline protection.
7.
Fill the cooling system with Dex Cool coolant.
GREASE
ZERKS
GREASE
ZERKS
6-1-05
4-30
Cooling System
__________________________________________________________
Figure 4-26: Geared Fan Drive Assembly
GEARED FAN DRIVE SEAL REPLACEMENT
CAUTION: DO NOT lift the GFD with the oil pipe. It may induce oil leaks.
NOTE: The disassembly and assembly process will require the use of a good quality shop press, do not attempt this procedure
without the proper tools.
With the GFD removed from the vehicle and drained of fluid, place it on a clean work bench free of dirt and debris.
CROSS
MEMBER
VISCOUS
DRIVE
GFD
ASSEMBLY
GFD DRIVE FLANGE
TO HARMONIC BALANCER
6-1-05
_________________________________________________________
Cooling System 4-31
5745804
Disassembly
1.
Remove the oil pipe (Figure 4-27).
Figure 4-27: Oil Pipe
2.
Remove the six bolts holding the sump assembly to the GFD and remove the sump.
OIL PIPE
FAN CASE
MAIN CASE
REAR CASE
OIL SUMP
12-1-05
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст