Hummer H1 (2006+). Manual — part 226
6-54
Wheels and Tires/Central Tire Inflation System (CTIS)
_______________
Figure 6-57: CTIS Interior Harness Appearance
AIR PRESSURE SWITCH REPLACEMENT
WARNING: The CTIS components are subject to high air pressure. Always relieve the air pressure before loosen-
ing or removing air system components by disconnecting quick-disconnect valve assemblies. Failure to follow this
warning may result in serious injury.
NOTE: The front and rear air pressure switches are replaced similarly.
Removal
1.
Disconnect the harness leads from the air pressure switch.
2.
Remove the air pressure switch from the manifold.
CAUTION: Do not allow sealant into the air system. Sealant will damage the CTIS components.
Installation
1.
Apply sealant to the threads and screw the air pressure switch into the manifold.
2.
Connect the harness leads to the air pressure switch.
I/P HARNESS
CONNECTOR
CTIS INTERIOR
HARNESS
SWITCH
CONNECTORS
AIR PRESSURE
GAUGE
______________
Wheels and Tires/Central Tire Inflation System (CTIS) 6-55
5745804
Figure 6-58: Air Pressure Switch Locations
AIR PRESSURE INDICATOR LINES REPLACEMENT
WARNING: The CTIS components are subject to high air pressure. Always relieve the air pressure before loosen-
ing or removing air system components by disconnecting quick-disconnect valve assemblies. Failure to follow this
warning may result in serious injury.
Removal
NOTE: Replacement procedures for the front and rear air pressure indicator lines are basically the same.
1.
Remove the CTIS module from the instrument panel.
NOTE: Mark the position of the air indicator lines before removing.
2.
Disconnect the air pressure indicator lines from the air pressure gauge (Figure 6-59).
CAUTION: Do not allow sealant into the air system. Sealant will damage the CTIS components.
NOTE: Apply sealant to the threads prior to installation.
Installation
1.
Connect the air pressure indicator lines to the air pressure gauge in the position they were in prior to removal (Figure 6-59).
2.
Install the CTIS module to the instrument panel.
REAR AIR
PRESSURE
SWITCH
FRONT
AIR PRESSURE
SWITCH
MANIFOLD
HARNESS
LEADS
6-56
Wheels and Tires/Central Tire Inflation System (CTIS)
_______________
Figure 6-59: Front Air Pressure Indicator Line
CTIS COMPRESSOR FUSE REPLACEMENT
Removal
1.
Raise and secure the hood.
2.
Remove the left side cowl cover and the fuse box cover.
3.
Remove the fuse from the box (Figure 6-60).
Installation
1.
Install the fuse in the fuse box (Figure 6-60).
2.
Install the plastic cover on the fuse box and install the left cowl cover.
3.
Lower and secure the hood.
GAUGE
AIR PRESSURE
AIR PRESSURE
LINES
INDICATOR
______________
Wheels and Tires/Central Tire Inflation System (CTIS) 6-57
5745804
Figure 6-60: CTIS Compressor Fuse Location
CTIS COMPRESSOR RELAY REPLACEMENT
Removal
1.
Raise and secure the hood.
2.
Remove left cowl cover and fuse box cover.
3.
Remove relay from fuse box (Figure 6-61).
Installation
1.
Install relay in fuse box (Figure 6-61).
2.
Install fuse box cover and left cowl cover.
3.
Lower and secure hood.
Figure 6-61: CTIS Compressor Relay Mounting
DEFLATE VALVE ASSEMBLY REPLACEMENT
WARNING: The CTIS components are subject to high air pressure. Always relieve the air pressure before loosen-
ing or removing air system components by disconnecting quick-disconnect valve assemblies. Failure to follow this
warning may result in serious injury.
CTIS
FUSE
CTIS
PUMP
RELAY
RELAY
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст