Hummer H1 (2006+). Manual — part 315
10-122 Body
____________________________________________________________________
Figure 10-149: Shield and Wiring Location
Domelight/Cargo Light Replacement Removal
1.
Remove the domelight lens (Figures 10-150, 10-151, and 10-152).
2.
Remove the lamp from the domelight.
3.
Remove the screws securing the domelight to the ground lead and the connector.
4.
Remove the screw and the domelight from the roof bracket.
Installation
1.
Secure the domelight, connector and the ground lead to the roof bracket with the screws (Figures 10-150, 10-151, and 10-152).
2.
Install the lamp in the domelight.
3.
Install the domelight lens.
SHIELD
LEADS
HOUSING
WIRING
CONNECTORS
BEAM
HARNESS
___________________________________________________________________
Body 10-123
Figure 10-150: Standard Domelight Replacement
Figure 10-151: Rear Domelight (HMCS)
ROOF BRACKET
GROUND LEAD
DOMELIGHT
LENS
LAMP
CONNECTOR
FRONT OF
VEHICLE
ROOF BRACKET
GROUND LEAD
DOMELIGHT
LENS
LAMP
CONNECTORS
FRONT OF
VEHICLE
10-124 Body
____________________________________________________________________
Figure 10-152: Cargo Light (HMCS)
Figure 10-153: Rear Seat Courtesy Light Replacement
ROOF BRACKET
GROUND LEAD
DOMELIGHT
LENS
LAMP
FRONT OF
VEHICLE
COURTESY
LOWER
B-PILLAR
TRIM
LIGHT
___________________________________________________________________
Body 10-125
Underhood Light Replacement
Removal
1.
Disconnect the two connectors from the wiring harness (Figure 10-154).
2.
Remove the two screws, washers, ground lead, bracket and the light from the hood.
3.
Remove the lamp from the light.
Installation
1.
Install the lamp in the light (Figure 10-154).
2.
Secure the light, bracket and the ground lead to the hood with the two washers and the capscrews.
3.
Connect the two connectors to the wiring harness.
Figure 10-154: Underhood Light Replacement
Daytime Running Lights (DRL) Module Replacement (Canada Only)
Removal
1.
Disconnect the Daytime Running Lights (DRL) connector from the harness assembly (Figure 10-155).
2.
Remove the two screws, washers, nuts and the DRL module from the kick panel.
Installation
1.
Secure the DRL module to the kick panel with the two screws, washers and the nuts (Figure 10-155).
2.
Connect the DRL connector to the harness assembly.
LIGHT
LAMP
BRACKET
HOOD
GROUND LEAD
CONNECTORS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст