Hummer H1 (2006+). Manual — part 173
3-34 Fuel, Emissions, and Exhaust
___________________________________________
.
Figure 3-19: Fuel Lines, Connections, and Attachment
VALVE
MOUNTING
BRACKET
RETURN LINE
(AUXILIARY TANK)
CLAMP
(TYPICAL)
SUPPLY LINE
(AUXILIARY TANK)
FUEL SELECTOR VALVE
TANK-TO-VALVE
LINES
FUEL LINE
BRACKET
TIE STRAP
___________________________________________
Fuel, Emissions, and Exhaust 3-35
Figure 3-20: Fuel Selector Valve and Fitting
Quick Connect Fittings
Quick connect fittings are used at the main tank fuel tubes, auxiliary tank fuel tubes, and at the fuel tank selector valve
(Figure 3-20).
The plastic fitting retainer only requires a screwdriver and needle nose pliers to remove.
Plastic Fittings
1.
To disconnect, raise the retainer tab with a small flat blade screwdriver and remove the retainer with needle nose pliers.
2.
To reconnect, push the fitting onto the tube, insert the retainer through the fitting sides, and seat it firmly.
3.
Be sure the retainer seats behind the fuel tube flange.
4.
Pull on the fitting afterward to verify proper seating.
FUEL SELECTOR
VALVE
TUBE
FUEL LINE
CLIP
3-36 Fuel, Emissions, and Exhaust
___________________________________________
Figure 3-21: Fuel Tank Vent Line Locations
Fuel Tank Vent Line Service
Removal
1.
Remove the fuel tank. (Refer to section 3)
2.
Remove the clip and the fuel tank vent line hose from the vent line (Figure 3-21).
3.
Remove the vent line clamps and disengage the lines.
4.
Remove the tie strap securing the vent line to the fuel lines. Discard the tie strap.
5.
Disconnect the fuel tank vent lines at the tank fittings and remove the lines.
Installation
1.
Connect the vent lines to the tank fittings.
2.
Secure the vent line to the fuel lines with a new tie strap (Figure 3-21).
3.
Secure the vent lines in the brackets with clamps and bolts.
4.
Install the fuel tank.
Main Fuel Tank Vent Filter
The main fuel tank vent filter is located just above the vacuum pump motor at the passenger side of the engine compartment.
The filter is serviced as an assembly and should be replaced if restricted or damaged.
Removal
1.
Remove the filter retaining clamp bolt and pull the filter out of the P clamp
2.
Disconnect the clamp from the filter’s vent line.
3.
Remove the filter from the vent line
Installation
1.
Connect the filter to the vent line.
2.
Install the vent line clamp.
3.
Install the filter in the P clamp and secure with the bolt.
FUEL TANK
VENT LINE
FUEL LINES
VENT LINE
BRACKETS
TIE STRAP
___________________________________________
Fuel, Emissions, and Exhaust 3-37
Figure 3-22: Fuel Tank Vent Filters
FUEL TANK
VENT LINE
ELBOW
BODY
BRACKET
P CLAMP
VENT LINE FILTER
VENT LINE
CLAMP
TIE STRAP
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст