Hummer H2. Manual — part 815
Fig. 14: Park Brake Lever Mounting Nuts
Courtesy of GENERAL MOTORS CORP.
2. Install the park brake lever.
3. Install the park brake lever mounting nuts.
Tighten: Tighten the nuts to 25 N.m (18 lb ft).
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2004 Hummer H2
2004 BRAKES Park Brake - Hummer H2
Fig. 15: Park Brake Release Lever Handle & Bolt
Courtesy of GENERAL MOTORS CORP.
4. Connect the park brake release cable to the park brake lever.
2004 Hummer H2
2004 BRAKES Park Brake - Hummer H2
Fig. 16: Park Brake Warning Lamp Connection
Courtesy of GENERAL MOTORS CORP.
5. Connect the park brake warning lamp connector.
6. Install the MID-Bussed Electrical Center bracket.
7. Install the left side hinge pillar panel. Refer to Trim Replacement - Hinge Pillar in Interior Trim.
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
(Single Battery) in Engine Electrical.
9. Enable the park brake cable automatic adjuster. Refer to Enabling the Park Brake Cable Automatic
Adjuster .
PARK BRAKE WARNING LAMP SWITCH REPLACEMENT
Removal Procedure
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
2004 Hummer H2
2004 BRAKES Park Brake - Hummer H2
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
(Single Battery) in Engine Electrical.
2. Remove the MID-Bussed Electrical Center from the bracket.
Fig. 17: Park Brake Warning Lamp Connection
Courtesy of GENERAL MOTORS CORP.
3. Disconnect the park brake warning lamp switch connector.
2004 Hummer H2
2004 BRAKES Park Brake - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст