Hummer H2. Manual — part 2101
This Document is Blank
The Article you are looking for
Either does not exist
For your vehicle,
Or has been covered in another section
This page has been left here by the template system
Please check another section for the information you
require
2004 STEERING
Steering Linkage (Non-Rack & Pinion) - Hummer H2
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
REPAIR INSTRUCTIONS
STEERING LINKAGE INSPECTION
1. Raise and suitably support the vehicle on safety stands. Refer to Lifting and Jacking the Vehicle in
General Information.
2. Turn the ignition switch to the ON position.
3. With the aid of an assistant, move the tire back and forth.
4. Inspect for excessive vertical or lateral movement and/or looseness in the pivot joints.
z
Tie rod ends
z
Idler arm
z
Pitman arm
5. Inspect for bent, damaged, or loose components.
6. Replace any worn or damaged pivot joints.
TIE ROD REPLACEMENT - OUTER
Tools Required
z
J 24319-B Universal Steering Linkage Puller. See Special Tools and Equipment .
z
J 29193 Steering Linkage Installer (12 mm). See Special Tools and Equipment .
Application
Specification
Metric
English
Idler Arm to Frame Nut
120 N.m
89 lb ft
Idler Arm to Relay Rod Nut
60 N.m
44 lb ft
Inner Tie Rod to Relay Rod
100 N.m
74 lb ft
Pitman Arm to Relay Rod Nut
60 N.m
44 lb ft
Pitman Arm to Steering Gear Nut
250 N.m
184 lb ft
Steering Dampener to Frame Bracket Nut
40 N.m
30 lb ft
Steering Dampener to Relay Rod Nut
40 N.m
30 lb ft
Outer Tie Rod Jam Nut
68 N.m
50 lb ft
Tie Rod to Steering Knuckle Nut
60 N.m
44 lb ft
2004 Hummer H2
2004 STEERING Steering Linkage (Non-Rack & Pinion) - Hummer H2
2004 Hummer H2
2004 STEERING Steering Linkage (Non-Rack & Pinion) - Hummer H2
Removal Procedure
Fig. 1: Outer Tie Rod Ball Stud & Nut
Courtesy of GENERAL MOTORS CORP.
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the nut from the outer tie rod ball stud (2).
Do not reuse the nut.
IMPORTANT: Use the J 24319-B in order to separate all the tie rods and ball joints. See
Special Tools and Equipment .
2004 Hummer H2
2004 STEERING Steering Linkage (Non-Rack & Pinion) - Hummer H2
Fig. 2: Removing Outer Tie Rod Assembly From Steering Knuckle
Courtesy of GENERAL MOTORS CORP.
3. Use the J 24319-B in order to remove the outer tie rod ball stud from the steering knuckle. See Special
Tools and Equipment .
2004 Hummer H2
2004 STEERING Steering Linkage (Non-Rack & Pinion) - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст