Hummer H2. Manual — part 1738
Fig. 147: View Of J 41476
Courtesy of GENERAL MOTORS CORP.
5. Rotate the crankshaft until two opposing flywheel bolt holes are parallel to the oil pan surface.
6. Install the J 41476 and bolts onto the rear of the crankshaft. See Special Tools and Equipment .
7. Tighten the J 41476 mounting bolts until snug. See Special Tools and Equipment . Do not overtighten.
Tighten:
IMPORTANT: The tapered legs of the alignment tool must enter the rear cover oil seal
bore.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
1. Tighten the oil pan-to-rear cover bolts to 12 N.m (106 lb in).
2. Tighten the engine rear cover bolts to 25 N.m (18 lb ft).
8. Remove the J 41476 . See Special Tools and Equipment .
9. Install a NEW crankshaft rear oil seal. Refer to Crankshaft Rear Oil Seal Replacement .
10. Install the engine flywheel. Refer to Engine Flywheel Replacement .
OIL FILTER ADAPTER REPLACEMENT
Removal Procedure
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
Fig. 148: View Of Engine Oil Filter
Courtesy of GENERAL MOTORS CORP.
1. Drain the engine oil.
2. Remove the oil filter.
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
Fig. 149: Oil Filter Adapter & Bypass Valve
Courtesy of GENERAL MOTORS CORP.
3. Remove the oil filter adapter (1).
Installation Procedure
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст