Hummer H2. Manual — part 1379
3. Pull out the fuse block out of the I/P in order to remove the retaining bolt.
4. Loosen the bolt.
5. Insert a screw driver between the wire harness block and fuse block in order to separate.
6. Separate the fuse block from the I/P harness block.
7. Remove the IP wiring harness block from the vehicle.
Installation Procedure
1. Install the fuse block to the I/P wire harness block.
2. Install the retaining bolt.
Tighten: Tighten the bolt to 6 N.m (53 lb in)
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
Fig. 127: Fuse Block & I/P
Courtesy of GENERAL MOTORS CORP.
3. Install the fuse block to the I/P till it clicks in place.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
Fig. 128: Connecting Wiring Connectors To Fuse Block
Courtesy of GENERAL MOTORS CORP.
4. Connect the wiring connectors to the fuse block.
Refer to Electrical Center Identification Views to ensure the right connections are made.
5. Install the right side end panel.
SPECIAL TOOLS AND EQUIPMENT
SPECIAL TOOLS
Special Tools
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
Illustration
Tool Number/Description
J 25070
Heat Gun 500-700 F
J 35616
GM Terminal Test Kit
J 35616-200
Test Light - Probe Kit
J 36169-A
Fused Jumper Wire
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст