Hummer H2. Manual — part 1733
the crankshaft.
4. Remove the tool and reverse the installation tool.
Position the larger end of the installer against the front of the balancer.
5. Use a wrench and hold the hex end of the threaded rod.
6. Use a second wrench and rotate the installation tool nut clockwise until the balancer is installed
onto the crankshaft.
7. Remove the balancer installation tool.
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
Fig. 130: Balancer Proper Installation Position
Courtesy of GENERAL MOTORS CORP.
3. Install the used crankshaft balancer bolt.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
Tighten: Tighten the USED crankshaft balancer bolt to 330 N.m (240 lb ft).
4. Remove the used crankshaft balancer bolt.
5. Measure for a correctly installed balancer.
If the balancer is not installed to the proper dimensions, install the J 41665 . See Special Tools and
Equipment .
6. Install a NEW crankshaft balancer bolt.
Tighten:
1. Tighten the crankshaft balancer bolt a first pass to 50 N.m (37 lb ft).
2. Tighten the crankshaft balancer bolt a second pass to 140 degrees using the J 45059 . See Special
Tools and Equipment .
7. Remove the J 42386-A .
8. Install the starter motor. Refer to Starter Motor Replacement .
9. Install the fan shroud. Refer to Fan Shroud Replacement .
10. Install the accessory drive belt (if not equipped with A/C). Refer to Drive Belt Replacement -
Accessory .
11. Install the A/C drive belt (if equipped). Refer to Drive Belt Replacement - Air Conditioning .
12. Perform the crankshaft position (CKP) system variation learn procedure. Refer to CKP System
Variation Learn Procedure .
CRANKSHAFT FRONT OIL SEAL REPLACEMENT
Tools Required
J 41478 Crankshaft Front Oil Seal Installer. See Special Tools and Equipment .
Removal Procedure
IMPORTANT: The nose of the crankshaft should be recessed 2.4-4.48 mm (0.094-0.176
in) into the balancer bore.
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
Fig. 131: Crankshaft Front Oil Seal
Courtesy of GENERAL MOTORS CORP.
1. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
2. Remove the crankshaft oil seal (1) from the front cover.
Installation Procedure
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст