Hummer H2. Manual — part 2308
Fig. 264: Reaction Gear Components
Courtesy of GENERAL MOTORS CORP.
1. Install the reaction carrier/support thrust bearing assembly (683) into the internal reaction gear support
(685).
2. Install the reaction gear support to case bearing (692) onto the internal reaction gear support (685). Retain
the bearing using J 36850 or equivalent.
3. Install the internal reaction gear (684) and the internal reaction gear support (685) into the case.
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
Fig. 265: Reaction Carrier Assembly
Courtesy of GENERAL MOTORS CORP.
4. Install the reaction carrier assembly (681) into the internal reaction gear.
LOW AND REVERSE CLUTCH SPACER PLATE SELECTION
Tools Required
z
J 8001 Dial Indicator Set
z
J 26900-13 Magnetic Indicator Base
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
Fig. 266: Low & Reverse Clutch Plates
Courtesy of GENERAL MOTORS CORP.
1. Inspect the low and reverse clutch plates for the following conditions:
z
Composition material wear
z
Composition material heat damage
z
Composition material delamination
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
z
Steel plates heat damage
z
Steel plates surface finish damage
Fig. 267: Low & Reverse Clutch Plate Assembly
Courtesy of GENERAL MOTORS CORP.
2. Stack the low and reverse clutch plate assembly on a flat surface in the following order:
1. One waved plate (682A)
2. Five fiber plate assemblies (682C) and four steel plates (682D), starting with one fiber plate
assembly and alternating with steel
3. Low and reverse clutch support (679)
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст