Hummer H2. Manual — part 1130
Tighten: Tighten the bolt to 12 N.m (106 lb in).
8. Install the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and
Underbody.
9. Lower the vehicle.
Fig. 20: Positive Battery Cable
Courtesy of GENERAL MOTORS CORP.
10. Install the positive battery cable (1) into the junction block.
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Tighten: Tighten the nut to 9 N.m (80 lb in).
11. Snap the junction block cover closed.
Fig. 21: Positive Battery Cable Bolt
Courtesy of GENERAL MOTORS CORP.
12. Tighten the positive cable bolt at the UBEC.
Tighten: Tighten the bolt to 9 N.m (80 lb in).
13. Position the UBEC lower cover.
14. Install the UBEC cover.
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Fig. 22: Battery Ground Negative Cable & Bolt
Courtesy of GENERAL MOTORS CORP.
15. Connect the positive battery cable.
Tighten: Tighten the bolt to 17 N.m (13 lb ft).
16. Snap the positive battery cable cap closed.
17. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
(Single Battery) .
GENERATOR CABLE REPLACEMENT
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Removal Procedure
Fig. 23: Battery Ground Negative Cable & Bolt
Courtesy of GENERAL MOTORS CORP.
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
(Single Battery) .
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст