Hummer H2. Manual — part 2015
GENERAL INFORMATION
Maintenance Reminder Lights - Hummer
CHANGE OIL SOON INDICATOR
2003 H2
1. The Oil Life System will show when to change the engine oil and oil filter. This will usually occur
between 3000 and 7500 miles since the last oil change. Under severe conditions, the indicator may come
on before 3000 miles. The system will not detect dust in the oil. Reset the system when the oil has been
changed.
2. To reset oil life system, turn ignition ON, with engine OFF. Fully push and release the accelerator pedal
slowly 3 times within 5 seconds. If the CHANGE OIL SOON light flashes, the system is resetting. Turn
ignition OFF. Start engine and all to idle. The oil life will change to 100 percent. If the CHANGE OIL
SOON indicator comes back on, the system has not reset. Repeat the procedure.
2004 H2
The vehicle has a computer system that has a change engine oil light, indicating when to change the engine oil
and filter. See Fig. 1 . This is based on engine revolutions and engine temperature, and not on mileage. Based
on driving conditions, the mileage at which an oil change will be indicated can vary considerably. For the oil
life system to work properly, the system must be reset every time the oil is changed.
When the system has calculated that oil life has been diminished, it will indicate that an oil change is necessary.
The change engine oil light will come on. The oil must be changed as soon as possible. It is possible that, if the
vehicle is driven under the best conditions, the oil life system may not indicate that an oil change is necessary
for over a year. However, the engine oil and filter must be changed at least once a year and at this time the
system must be reset. If the system is ever reset accidentally, the oil must be changed at 3000 miles since the
last oil change. Remember to reset the oil life system whenever the oil and filter is changed.
1. Press the fuel information button until Engine Oil Life appears on the screen.
NOTE:
Most vehicles are equipped with a Malfunction Indicator Light (MIL) or check
engine light. If light comes on and remains on while driving, the vehicle requires
some type of repair. See appropriate service and repair information. After
repairing fault(s) and clearing fault code(s), the MIL or check engine light
should go out. Some models may use a dual-function indicator light, which is
also used to indicate emission component service is due. After performing
required service, reset indicator light.
NOTE:
This article is only to be used for resetting maintenance reminder lights (when
applicable). Some models (not all) may be equipped with one or more resetable
maintenance reminder lights indicating maintenance is required. Once required
maintenance services are performed, resetting of lights may be required.
Information is provided to reset these lights where applicable.
2004 Hummer H2
GENERAL INFORMATION Maintenance Reminder Lights - Hummer
2004 Hummer H2
GENERAL INFORMATION Maintenance Reminder Lights - Hummer
2. Press and hold the select button for 5 seconds.
3. OIL LIFE RESET will appear on the screen for 10 seconds.
4. The oil life system is reset.
Fig. 1: Identifying Instrument Cluster (2004 H2)
Courtesy of GENERAL MOTORS CORP.
2004 Hummer H2
GENERAL INFORMATION Maintenance Reminder Lights - Hummer
2004 GENERAL INFORMATION
Maintenance and Lubrication - Hummer H2
SPECIFICATIONS
CAPACITIES - APPROXIMATE FLUID
Capacities - Approximate Fluid
FLUID AND LUBRICANT RECOMMENDATIONS
Fluid and Lubricant Recommendations
Application
Specification
Metric
English
Air Conditioning Refrigerant R-134a
1.6 lb
0.7 KS
Axles
z
Front Axle
1.73 Liters
1.83 Pints
z
Rear Axle
2.6 Liters
2.75 Quarts
Engine Cooling System
z
6.0L V8
12.7 Liters
13.0 Quarts
Engine Crankcase
z
6.0L V8
5.7 Liters
6.0 Quarts
Fuel Tank
121.0 Liters
32.0 Gallons
Transmission
z
4L60-E After Filter/Pan Removal
4.7 Liters
5.0 Quarts
z
After Complete Overhaul - 4L60-E
10.6 Liters
11.0 Quarts
Transfer Case
Borg Warner 4484
1.4 Liters
1.5 Quarts
Wheel Nut Torque
140 ft lb
190 N.m
Application
Fluid/Lubricant
Automatic Transmission
DEXTRON(R) III Automatic Transmission Fluid
Chassis Lubrication
Chassis Lubrication GM P/N 12377985 or equivalent or lubricant meeting
requirements of NLGI # 2, Category LB or GC-LB
Clutch linkage Pivot
Points
Engine Oil
Engine Coolant
50/50 mixture of clean, drinkable water and use only GM DEX-COOL(R) or
Havoline DEX-COOL(R) coolant.
Engine Oil
Engine oil with the American Petroleum Institute Certified for Gasoline
Engines "Starburst" symbol of the proper viscosity.
Front and Rear Axle
SAE 75W-90 Synthetic Axle Lubricant GM P/N 12378261 (Canadian P/N
2004 Hummer H2
2004 GENERAL INFORMATION Maintenance and Lubrication - Hummer H2
2004 Hummer H2
2004 GENERAL INFORMATION Maintenance and Lubrication - Hummer H2
TIRE INFLATION PRESSURE SPECIFICATIONS
When you inflate the tires to the recommended inflation pressures, the factory-installed wheels and tires are
designed to handle loads to the tire's rated load capacity. Incorrect tire pressures, or under-inflated tires, can
cause the following conditions:
z
Vehicle handling problems
z
Poor fuel economy
z
Shortened tire life
z
Tire overloading
Check the tire pressure when the following apply:
z
The tires are cool.
z
The vehicle has not been driven for more than 3 hours.
z
The vehicle has been driven less than 1.6 km (1 mi).
Check the tires monthly or before any extended trip. Adjust the tire pressure to the specifications on the tire
placard. Refer to Label - Vehicle Certification (w/o RPO Z49) or Label - Vehicle Certification (w/RPO
Z49) in General Information. Install the valve caps or extensions on the valves. These keep out dust and water.
The kilopascal (kPa) is the metric term for tire inflation pressure. The tire pressure may be printed in both
kilopascal (kPa) and psi. One psi equals 6.9 kPa.
10953455) or equivalent meeting GM Specification 9986115.
Hood and Door Hinges
Multi-Purpose Lubricant, Superlube GM P/N 12346241 (Canadian P/N
10953474) or equivalent.
Hydraulic Brake System
Delco(R) Supreme II Brake Fluid GM P/N 12377967 (Canadian P/N
992667) or equivalent DOT P/N 3 Brake Fluid
Key Lock Cylinders
Multi-Purpose Lubricant, Superlube GM P/N 12346241 (Canadian P/N
10953474) or equivalent.
Outer Tailgate Handle
Pivot Points and Hinges
Multi-Purpose Lubricant, Superlube GM P/N 12346241 (Canadian P/N
10953474) or equivalent.
Power Steering System
GM Power Steering Fluid GM P/N 1052884 - 1 pint, GM P/N 1050017 - 1
quart, (Canadian P/N 993294) - 1 pint, (Canadian P/N 992646) - 1 quart or
equivalent.
Transfer Case
DEXRON(R) III Fluid GM P/N 12346143 (Canadian P/N 10952622).
Weatherstrip Conditioning Dielectric Silicone Grease GM P/N 12345579 (Canadian P/N 1974984) or
equivalent.
Weatherstrip Squeaks
Synthetic Grease with Teflon, Superlube GM P/N 12371287 (Canadian P/N
10953437) or equivalent.
Windshield Washer
Solvent
GM Optikleen Washer Solvent GM P/N 1051515 (Canadian P/N 993033) or
equivalent.
2004 Hummer H2
2004 GENERAL INFORMATION Maintenance and Lubrication - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст