Hummer H2. Manual — part 2751
Fig. 50: Using J 2619-01 & J 45548 To Remove Mainshaft Rear Support Bushing
Courtesy of GENERAL MOTORS CORP.
58. Inspect the mainshaft rear support bushing in the rear output shaft for being faulty. Refer to Cleaning
and Inspection .
59. Using the J 2619-01 (1) and the J 45548 (2), remove the mainshaft rear support bushing from the rear
2004 Hummer H2
2004 DRIVELINE/AXLE Transfer Case - Overhaul - BW 4482-NR4
output shaft.
Fig. 51: Identifying J 26941 & J 23907
Courtesy of GENERAL MOTORS CORP.
60. Using the J 26941 (1) and the J 23907 (2), remove the rear bearing for the front output shaft from the rear
case.
2004 Hummer H2
2004 DRIVELINE/AXLE Transfer Case - Overhaul - BW 4482-NR4
Fig. 52: View Of Shift Detent Lever Shaft Seal
Courtesy of GENERAL MOTORS CORP.
61. Remove the seal for the shift detent lever shaft by prying it out from the case.
CLEANING AND INSPECTION
Front Case Half
1. Clean the front case half in cleaning solvent and air dry.
2004 Hummer H2
2004 DRIVELINE/AXLE Transfer Case - Overhaul - BW 4482-NR4
Fig. 53: View Of Front Case Inspection Areas
Courtesy of GENERAL MOTORS CORP.
2. Remove the shavings from the case half bolt holes.
3. Remove the sealer from the case sealing surfaces.
4. Inspect the case for being broken or cracked.
5. Inspect the front output shaft front bearing bore (5) for the following conditions:
z
A spun bearing
z
Cracks
6. Inspect the input shaft bearing bore (4) for the following conditions:
z
A spun bearing
z
Cracks
NOTE:
Refer to Machined Surface Damage Notice in Cautions and Notices.
2004 Hummer H2
2004 DRIVELINE/AXLE Transfer Case - Overhaul - BW 4482-NR4
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст