Hummer H2. Manual — part 1374
Fig. 109: Splices S900, S901 and S902 Component Views
Courtesy of GENERAL MOTORS CORP.
Callouts For Fig. 109
Callout
Component Name
1
Center High Mounted Stop Lamp (CHMSL) Connector
2
Rear Window Defogger Grid Connector
3
Rear Window Defogger Grid Connector
4
Splice S900
5
Rear Window Wiper Module - w/Motor
6
Door Lock Actuator - Liftgate
7
Liftgate Ajar Switch - Left
8
Liftgate Ajar Switch - Right
9
Splice S902
10
Splice S901
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
REPAIR INSTRUCTIONS
RELAY REPLACEMENT (WITHIN AN ELECTRICAL CENTER)
Tools Required
J 43244 Relay Puller Pliers. See Special Tools and Equipment .
Removal Procedure
1. Remove the electrical center cover.
2. Locate the relay. Refer to Electrical Center Identification Views to locate the electrical center where the
relay exists.
IMPORTANT:
z
Always note the orientation of the relay.
z
Ensure that the electrical center is secure, as not to put added stress
on the wires or terminals.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
Fig. 110: Removing Or Installing Relay In Electrical Center
Courtesy of GENERAL MOTORS CORP.
3. Using the J 43244 (1) position the tool on opposing corners of the relay (2). See Special Tools and
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
Equipment .
4. Remove the relay (2) from the electrical center.
Installation Procedure
NOTE:
Use J43244 to pull the relay straight out from the electrical center
terminals. The use of pliers or a flat bladed tool could damage the
electrical center.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст