Hummer H2. Manual — part 2725
Fig. 73: View Of Front Case Vent
Courtesy of GENERAL MOTORS CORP.
5. If the vent is removed, apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the threads on
the vent.
6. Install the vent.
Tighten: Tighten the vent to 6 N.m (53 lb in).
2004 Hummer H2
2004 DRIVELINE/AXLE Transfer Case - Overhaul - BW 4482-NR4
Fig. 74: Identifying Annulus Gear
Courtesy of GENERAL MOTORS CORP.
7. Install the annulus gear in the front case half.
2004 Hummer H2
2004 DRIVELINE/AXLE Transfer Case - Overhaul - BW 4482-NR4
Fig. 75: Locating Retaining Ring For Annulus Gear
Courtesy of GENERAL MOTORS CORP.
8. Install a NEW retaining ring for the annulus gear.
2004 Hummer H2
2004 DRIVELINE/AXLE Transfer Case - Overhaul - BW 4482-NR4
Fig. 76: Installing Input Shaft Bearing
Courtesy of GENERAL MOTORS CORP.
9. Install the input shaft bearing in the front case half.
z
Use a hammer and a brass drift only on the outer bearing race.
z
Ensure the bearing is kept square to the bore while installing.
IMPORTANT: Lubricate all of the bearings and bearing journals with transfer case fluid
during installation.
2004 Hummer H2
2004 DRIVELINE/AXLE Transfer Case - Overhaul - BW 4482-NR4
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст