Hummer H2. Manual — part 517
Fig. 19: Passenger Door Lock & Side Window Switch
Courtesy of GENERAL MOTORS CORP.
1. Connect the electrical connector to the door lock and side window switch.
2. Align the switch with the opening in the door panel. Press to seat the switch.
3. Program the keyless entry transmitters if the module has been replaced. Refer to Transmitter
Programming in Keyless Entry.
HANDLE BEZEL REPLACEMENT - INSIDE
Removal Procedure
1. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door or Trim Panel
Replacement - Side Rear Door .
2. Place the door trim panel, back-side up, on a clean prepared non-abrasive surface.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Doors - Hummer H2
Fig. 20: Inside Pull Handle Bezel Assembly
Courtesy of GENERAL MOTORS CORP.
3. Locate the 2 lower heat-stakes holding the pull handle bezel assembly to the door panel (3).
4. Using a 8 mm (5/16 in) drill bit, drill through the round heat-staked studs (3).
Drill into the heat-staked stud just enough to cause the stud material to separate from the door panel.
IMPORTANT: If the heat-stake is beaded, grin off the bead. Do not remove any door trim
material.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Doors - Hummer H2
5. Using a Dremel tool or equivalent, remove any heat-stake material that may be left in the door panel
holes or on the door panel.
6. Grind off the heat-stake material (4).
7. Remove the screws (2).
8. Using pliers, straighten the pull handle bezel tabs (1). Grind any remaining material if necessary.
9. Remove the pull handle bezel assembly from the door panel.
Installation Procedure
Fig. 21: Inside Pull Handle Bezel Assembly
Courtesy of GENERAL MOTORS CORP.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Doors - Hummer H2
1. Position the replacement pull handle bezel assembly to the door trim panel.
2. Place the door trim panel, back-side up, on a clean prepared non-abrasive surface.
3. Install the 2 screws (2).
Tighten: Tighten the screws to 2.8 N.m (25 lb in).
4. Use clamps to temporarily secure handle bezel to door trim panel.
5. Using a Weller model 8200 soldering gun, or equivalent, equipped with a flat tip, heat and bend the tabs
(1) securing the handle bezel to the door panel.
6. Heat the tabs (4) securing the handle bezel to the door panel.
7. Use a soldering gun equipped with a flat tip. Using a circular motion, apply firm steady pressure to spread
the heat-stake (3) material into the door trim panel to achieve a proper weld.
8. Allow for heat-stakes to cool and remove clamps.
9. Verify that the pull handle bezel is securely heat-staked to the door trim panel.
10. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door or Trim Panel
Replacement - Side Rear Door .
HANDLE BEZEL REPLACEMENT - INSIDE - FRONT
Removal Procedure
NOTE:
Refer to Fastener Notice in Cautions and Notices.
IMPORTANT: A desirable round heat-stake weld should have an approximate diameter
of 13 mm (1/2 in) and height 2 mm (3/32 in).
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Doors - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст