Hummer H2. Manual — part 2022
Fig. 2: Locating Driver Air Bag Yellow 4-Pin Connector
Courtesy of GENERAL MOTORS CORP.
2004 Hummer H2
GENERAL INFORMATION Air Bag Deactivation Procedures - Hummer
Fig. 3: Locating Passenger Air Bag Yellow 2-Pin Connector
Courtesy of GENERAL MOTORS CORP.
Activating System
Remove key from ignition switch. Ensure SDM fuse is still removed from fuse block. In reverse order, connect
SIR component Yellow SIR connectors to vehicle harness and install CPA clips. Install SIR fuse in fuse block.
Staying away from air bags, turn ignition switch to ON position. Ensure AIR BAG warning light flashes 7
times, and then turns off. To complete installation, reverse removal procedures.
2004 Hummer H2
GENERAL INFORMATION Air Bag Deactivation Procedures - Hummer
2004 RESTRAINTS
SIR - Hummer H2
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
SCHEMATIC AND ROUTING DIAGRAMS
SIR SCHEMATIC ICONS
SIR Schematic Icons
Application
Specification
Metric
English
Inflatable Restraint Front End Sensor
10 N.m
89 lb in
Inflatable Restraint Instrument Panel Module
10 N.m
89 lb in
Inflatable Restraint (SD) Module
10 N.m
89 lb in
Icon
Icon Definition
CAUTION:
When performing service on or near the SIR components or the SIR
wiring, the SIR system must be disabled. Refer to SIR Disabling and
Enabling Zones. Failure to observe the correct procedure could cause
deployment of the SIR components, personal injury, or unnecessary
SIR system repairs.
IMPORTANT:
In order to prevent accidental deployment, the shorting bars close in
order to short the connectors when the connectors are separated.
2004 Hummer H2
2004 RESTRAINTS SIR - Hummer H2
2004 Hummer H2
2004 RESTRAINTS SIR - Hummer H2
SIR SCHEMATICS
Fig. 1: SDM Power, Grounding, DLC, Sensors, and Driver Air Bag Schematic
Courtesy of GENERAL MOTORS CORP.
2004 Hummer H2
2004 RESTRAINTS SIR - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст