Hummer H2. Manual — part 2568
Tighten: Tighten the bolts to 29 N.m (21 lb ft).
9. Remove the J 25025-1 .
Fig. 242: Locating Pump To Case Bolts & O-Ring Seals
Courtesy of GENERAL MOTORS CORP.
10. Install the remaining pump to case bolts (2) and O-ring seals (3), in the holes where the J 25025-1 were.
Tighten: Tighten the bolts to 29 N.m (21 lb ft).
TRANSMISSION END PLAY CHECK
Tools Required
z
J 25022 End Play Fixture Adapter. See Special Tools and Equipment .
2004 Hummer H2
2004 TRANSMISSION/TRANSAXLE Automatic Transmission - Overhaul - 4L60-E/4L65-E
z
J 34725 End Play Checking Adapter. See Special Tools and Equipment .
z
J 43205 End Play Fixture Adapter (300 mm). See Special Tools and Equipment .
z
J 24773-A Oil Pump Remover. See Special Tools and Equipment .
z
J 8001 Dial Indicator Set. See Special Tools and Equipment .
z
J 25025-7A Dial Indicator Post. See Special Tools and Equipment .
Fig. 243: Identifying Different End Play Fixture Adapters
Courtesy of GENERAL MOTORS CORP.
1. Install an end play fixture adapter.
IMPORTANT: Torque converter size is model dependent.
2004 Hummer H2
2004 TRANSMISSION/TRANSAXLE Automatic Transmission - Overhaul - 4L60-E/4L65-E
z
Use J 25022 for a 245 mm and 258 mm turbine shaft (1).
z
Use J 34725 for a 298 mm turbine shaft (2).
z
Use J 43205 for a 300 mm turbine shaft (3).
Fig. 244: Identifying J 24773-A
Courtesy of GENERAL MOTORS CORP.
2. Install the J 24773-A .
2004 Hummer H2
2004 TRANSMISSION/TRANSAXLE Automatic Transmission - Overhaul - 4L60-E/4L65-E
Fig. 245: Installing J 25025-7A With J 8001
Courtesy of GENERAL MOTORS CORP.
3. Remove an oil pump bolt.
4. Install J 25025-7A (or a 278 mm or 11 in bolt) and lock nut.
5. Install J 8001 .
2004 Hummer H2
2004 TRANSMISSION/TRANSAXLE Automatic Transmission - Overhaul - 4L60-E/4L65-E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст