Hummer H2. Manual — part 352
Fig. 121: Adhesive Strip To Body
Courtesy of GENERAL MOTORS CORP.
2. Remove the screws retaining the tail lamp guard.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Lighting Systems - Hummer H2
Fig. 122: Tubular Tail Lamp Guard
Courtesy of GENERAL MOTORS CORP.
3. Carefully separate adhesive strip from body.
4. Remove the tail lamp guard from the vehicle.
Installation Procedure
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Lighting Systems - Hummer H2
Fig. 123: Tubular Tail Lamp Guard
Courtesy of GENERAL MOTORS CORP.
1. Position the tail lamp guard to the vehicle.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Lighting Systems - Hummer H2
Fig. 124: Tubular Tail Lamp Guard Screws
Courtesy of GENERAL MOTORS CORP.
2. Install the screws retaining the tail lamp guard.
Tighten: Tighten to 6 N.m (53 lb in).
3. Clean the surface where the adhesive strip will mount with varnish and makers (VMP) naptha.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Lighting Systems - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст