Hummer H2. Manual — part 884
Fig. 119: Applying Gear Marking Compound To Ring Gear Teeth
Courtesy of GENERAL MOTORS CORP.
2. Use a medium stiff brush in order to sparingly apply gear marking compound, GM P/N 1052351
(Canadian P/N 10953497) or equivalent, to all of the ring gear teeth.
3. Torque the bearing caps bolts to specification.
IMPORTANT: Performing a test without loading the gears will not produce a satisfactory
2004 Hummer H2
2004 DRIVELINE/AXLE Rear Drive Axle - Hummer H2
4. Apply the park brake until a torque load of 14 N.m (10 lb ft) is required in order to turn the pinion.
5. Using a wrench, turn the drive pinion flange/yoke so that the ring gear rotates 3 full revolutions.
6. Turn the drive pinion flange/yoke in the opposite direction so that the ring gear rotates 3 full revolutions
in the opposite direction.
7. Observe the pattern on the ring gear teeth. Compare the pattern with the following illustrations.
Correct Contact Pattern
Condition
Fig. 120: Correct Contact Pattern
Courtesy of GENERAL MOTORS CORP.
The backlash and pinion depth is correct.
Correction
None required.
Service Hints
pattern.
IMPORTANT: Avoid turning the ring gear excessively.
2004 Hummer H2
2004 DRIVELINE/AXLE Rear Drive Axle - Hummer H2
Loose bearings on the drive pinion or in the differential case may cause patterns that vary. If the contact pattern
varies, inspect the following preload settings:
z
Total assembly
z
Differential case
z
Pinion
If these settings are correct, inspect for damage or incorrectly assembled parts.
Drive Side Heel - Coast Side Toe Contact Pattern
Fig. 121: Drive Side Heel - Coast Side Toe Contact Pattern
Courtesy of GENERAL MOTORS CORP.
Condition
The backlash is incorrect. The ring gear is too far away from the pinion.
Correction
Decrease the backlash. Move the ring gear closer to the pinion by adjusting the side bearing shim thickness or
the adjuster sleeve(s). Refer to Backlash Adjustment .
Drive Side Toe - Coast Side Heel Contact Pattern
2004 Hummer H2
2004 DRIVELINE/AXLE Rear Drive Axle - Hummer H2
Fig. 122: Drive Side Toe - Coast Side Heel Contact Pattern
Courtesy of GENERAL MOTORS CORP.
Condition
The backlash is incorrect. The ring gear is too close to the drive pinion.
Correction
Increase the backlash. Move the ring gear away from the pinion by adjusting the side bearing shim thickness or
the adjuster sleeve(s). Refer to Backlash Adjustment .
Drive Side Heel - Coast Side Heel Contact Pattern
2004 Hummer H2
2004 DRIVELINE/AXLE Rear Drive Axle - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст