Hummer H2. Manual — part 2133
21. Install the pitman shaft seals and bearing. Refer to Pitman Shaft Seals and Bearing Replacement - Off
Vehicle (700 Gear) .
22. To adjust the steering gear; refer to one of the following procedures:
z
Worm Thrust Bearing Preload Adjustment - Off Vehicle (700 Gear)
z
Pitman Shaft Over-Center Preload Adjustment - Off Vehicle (670 Gear)
PITMAN SHAFT SEALS AND BEARING REPLACEMENT - OFF VEHICLE (700 GEAR)
Tools Required
z
J 6278 Pitman Shaft Bearing Remover and Installer. See Special Tools and Equipment .
z
J 4245 Internal Snap Ring Pliers. See Special Tools and Equipment .
Disassembly Procedure
steering gear housing.
2004 Hummer H2
2004 STEERING Power Steering System - Hummer H2
Fig. 74: Removing Pitman Arm & Pitman Shaft Boot From Steering Gear
Courtesy of GENERAL MOTORS CORP.
1. Remove the pitman shaft and the side cover. Refer to Steering Gear Pitman Shaft and Housing Cover
Replacement - Off Vehicle (700 Gear) .
2. Remove the pitman arm (3) from the steering gear (1).
3. Remove the pitman shaft boot (2).
2004 Hummer H2
2004 STEERING Power Steering System - Hummer H2
Fig. 75: Installing Retaining Ring Using J 4245 (700 Gear)
Courtesy of GENERAL MOTORS CORP.
4. Remove the dust seal (1).
5. Remove the retaining ring using the J 4245 . See Special Tools and Equipment .
2004 Hummer H2
2004 STEERING Power Steering System - Hummer H2
Fig. 76: Prying Backup Washer & Double Lip Seal From Steering Gear Housing
Courtesy of GENERAL MOTORS CORP.
6. Use a screwdriver to pry the backup washer (3) and the double lip seal (2) from the steering gear housing
(1).
7. Inspect the steering gear housing (1) for burrs.
IMPORTANT: Use care not to score the steering gear housing bore when prying out the
seals and the washers.
2004 Hummer H2
2004 STEERING Power Steering System - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст