Hummer H2. Manual — part 1866
Fig. 623: View Of J 41480 Installed
Courtesy of GENERAL MOTORS CORP.
3. Install the J 41480 . See Special Tools and Equipment .
NOTE:
Refer to Fastener Notice in Cautions and Notices.
IMPORTANT: Start the tool-to-front cover bolts. Do not tighten the bolts at this time.
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
Tighten: Tighten the tool-to-engine block bolts to 25 N.m (18 lb ft).
Fig. 624: View Of J 41476 & J 41480 Installed
Courtesy of GENERAL MOTORS CORP.
4. Install the J 41476 . See Special Tools and Equipment .
5. Install the crankshaft balancer bolt.
IMPORTANT: Align the tapered legs of the tool with the machined alignment surfaces
on the front cover.
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
Tighten:
1. Tighten the crankshaft balancer bolt by hand until snug. Do not overtighten.
2. Tighten the J 41480 . See Special Tools and Equipment .
3. Tighten the engine front cover bolts to 25 N.m (18 lb ft).
6. Remove the tools.
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
Fig. 625: Front Cover-To-Engine Block Proper Installation Position
Courtesy of GENERAL MOTORS CORP.
7. Measure the oil pan surface flatness, front cover-to-engine block.
2004 Hummer H2
2004 ENGINE Engine Mechanical - 4.8L, 5.3L, and 6.0L - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст