Hummer H2. Manual — part 2673

Fig. 46: Rear Output Shaft Seal
Courtesy of GENERAL MOTORS CORP.

15. Remove the rear output shaft seal by prying it out with a flat-blade screwdriver.

16. Remove the shipping seal from the rear output shaft, if equipped.

NOTE:

Refer to Transfer Case Seal Removal Notice in Cautions and Notices.

2004 Hummer H2

2004 DRIVELINE/AXLE Transfer Case - BW 4484 - Hummer H2

Fig. 47: Transfer Case Retaining Bolts & Washers
Courtesy of GENERAL MOTORS CORP.

17. Remove the transfer case retaining bolts and washers.

Mark the location of the brackets.

2004 Hummer H2

2004 DRIVELINE/AXLE Transfer Case - BW 4484 - Hummer H2

Fig. 48: Identifying J 45358
Courtesy of GENERAL MOTORS CORP.

18. Using the J 45358 between the tabs on the case halves, shear the sealer that is holding the case halves

together. See Special Tools and Equipment .

19. Using pry bars at each side of the case, remove the case from the locating pins.

NOTE:

Refer to Machined Surface Damage Notice in Cautions and Notices.

2004 Hummer H2

2004 DRIVELINE/AXLE Transfer Case - BW 4484 - Hummer H2

Fig. 49: Rear Case Half
Courtesy of GENERAL MOTORS CORP.

20. Remove the rear case half from the front case half. The rear output shaft will come with the rear case half.

2004 Hummer H2

2004 DRIVELINE/AXLE Transfer Case - BW 4484 - Hummer H2