Hummer H2. Manual — part 927
2. Turn the J 36615 counterclockwise in order to remove the differential bearing adjuster nut, the O-
ring seal and the differential side bearing cup. See Special Tools and Equipment .
Fig. 82: Installing J 8614-01 Onto Pinion Yoke
Courtesy of GENERAL MOTORS CORP.
30. Install the J 8614-01 as shown. See Special Tools and Equipment .
Remove the pinion nut while holding the J 8614-01 . See Special Tools and Equipment .
31. Remove the washer.
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Fig. 83: Installing J 8614-2 & J 8614-3 Into J 8614-01
Courtesy of GENERAL MOTORS CORP.
32. Install the J 8614-2 (2) and the J 8614-3 (3) into the J 8614-01 (1) as shown. See Special Tools and
Equipment .
33. Remove the pinion yoke by turning the J 8614-3 (3) clockwise while holding the J 8614-01 (1). See
Special Tools and Equipment .
34. Remove the pinion oil seal using a suitable seal removal tool.
IMPORTANT: Carefully pry the seal from the bore. Do not distort or scratch the
aluminum case.
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Fig. 84: Installing J 45765 To Left Side Differential Carrier Case Half Over Drive Pinion
Courtesy of GENERAL MOTORS CORP.
35. Install the J 45765 to the left side differential carrier case half over the drive pinion as shown. See
Special Tools and Equipment .
36. Turn the forcing screw of the J 45765 clockwise to remove the following components from the left side
differential carrier case half:
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
z
The drive pinion gear
z
The pinion gear selectable shim
z
The inner pinion bearing
z
The collapsible spacer
37. Remove the collapsible spacer from the pinion.
38. Remove the outer pinion bearing from the differential carrier case half.
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст