Hummer H2. Manual — part 964
Fig. 59: Installing J 45755-2, J 45755-1, Forcing Screw, Bearing & Washers Over Differential
Carrier Assembly Bushing
Courtesy of GENERAL MOTORS CORP.
2. Install the J 45755-2 (2), J 45755-1 (3), and the forcing screw, bearing and washers (1) over the
differential carrier assembly bushing as shown.
3. Press the bushing into the differential carrier assembly bushing bore using the J 45755 . See Special
Tools and Equipment .
4. Install the differential carrier assembly. Once the differential carrier assembly is installed, remove the
piece of tape in order to connect the vent hose. Refer to Differential Carrier Assembly Replacement .
DIFFERENTIAL CARRIER ASSEMBLY BUSHING REPLACEMENT (INNER AXLE SHAFT
HOUSING)
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Tools Required
J 45755 Front Axle Bushing Remover/Installer. See Special Tools and Equipment .
Removal Procedure
1. Remove the inner shaft housing. Refer to Inner Shaft and/or Housing Replacement - Front Drive
Axle .
2. Install the inner shaft housing into a vise.
Fig. 60: Installing J 45755-2, J 45755-1, Forcing Screw, Bearing & Washers Over Inner Shaft
Housing Bushing
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Courtesy of GENERAL MOTORS CORP.
3. Install the J 45755-2 (2), J 45755-1 (1), and the forcing screw, bearing and washers (3) over the inner
shaft housing bushing as shown.
4. Remove the inner shaft housing bushing using the J 45755 . See Special Tools and Equipment .
Installation Procedure
1. Install the inner shaft bushing into the inner shaft housing bushing bore.
Ensure that the inner shaft bushing is positioned so that the bushing is being driven in from the front of
the inner shaft housing towards the rear of the inner shaft housing.
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Fig. 61: Installing J 45755-2, J 45755-1, Forcing Screw, Bearing & Washers Inner Shaft Housing
Bushing
Courtesy of GENERAL MOTORS CORP.
2. Install the J 45755-2 (2), J 45755-1 (1), and the forcing screw, bearing and washers (3) over the inner
shaft housing bushing as shown.
3. Press the bushing into the inner shaft housing bore using the J 45755 . See Special Tools and
Equipment .
4. Remove the inner shaft housing from the vise.
5. Install the inner shaft housing. Refer to Inner Shaft and/or Housing Replacement - Front Drive Axle .
DIFFERENTIAL CARRIER ASSEMBLY REPLACEMENT
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст