Hummer H2. Manual — part 916
1. Remove the inner axle shaft and housing assembly from the differential carrier case assembly.
Refer to Inner Shaft and/or Housing Replacement - Front Drive Axle .
2. Install the inner axle shaft housing into a vise.
Clamp only on the mounting flange of the inner axle shaft housing.
3. Install the J 29369-2 behind the inner axle shaft seal. See Special Tools and Equipment .
4. Install the J 2619-01 (2) to the J 29369-2 (1). See Special Tools and Equipment .
5. Remove the inner axle shaft seal using the J 2619-01 .
Fig. 45: Installing J 29369-02 Behind Inner Axle Shaft Seal
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Courtesy of GENERAL MOTORS CORP.
4. If replacing the right side bearing, perform the following steps:
1. Remove the inner axle shaft and housing assembly from the differential carrier case assembly.
Refer to Inner Shaft and/or Housing Replacement - Front Drive Axle .
2. Install the inner axle shaft housing into a vise.
Clamp only on the mounting flange of the inner axle shaft housing.
3. Install the J 29369-2 behind the inner axle shaft seal. See Special Tools and Equipment .
4. Install the J 2619-01 (2) to the J 29369-2 (1). See Special Tools and Equipment .
5. Remove the inner axle shaft seal using the J 2619-01 .
6. Install the J 29369-2 behind the inner axle shaft bearing. See Special Tools and Equipment .
7. Install the J 2619-01 (2) to the J 29369-2 (1). See Special Tools and Equipment .
8. Remove the inner axle shaft bearing using the J 2619-01 .
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Fig. 46: Installing J 29369-2 Behind Inner Axle Shaft Seal Or Inner Axle Shaft Bearing
Courtesy of GENERAL MOTORS CORP.
5. If replacing the left side seal and/or bearing, perform the following steps:
1. Remove the differential carrier assembly. Refer to Differential Carrier Assembly Replacement .
2. Place the differential carrier assembly into a vise.
Clamp only on the mounting flange of the differential carrier assembly case.
3. Remove the inner axle shaft using a hammer and a brass drift.
4. Install the J 29369-2 (2) behind the inner axle shaft seal or the inner axle shaft bearing as
necessary. See Special Tools and Equipment .
5. Install the J 2619-01 (1) to the J 29369-2 (2). See Special Tools and Equipment .
6. Remove the inner axle shaft seal and/or the inner axle shaft bearing using the J 2619-01 .
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Installation Procedure
Fig. 47: Installing Bearing With Square Shoulder Using J 36609 & J 8092
Courtesy of GENERAL MOTORS CORP.
1. If installing the right side bearing, perform the following steps:
1. Install the inner axle shaft housing into a vise.
Clamp only on the mounting flange of the inner axle shaft housing.
2. Install the bearing with the square shoulder in using the J 36609 (1) and the J 8092 (2). See Special
Tools and Equipment .
2. If installing the right side inner axle shaft seal, perform the following steps:
1. Install the inner axle shaft housing into a vise.
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст