Hummer H2. Manual — part 1259
Fig. 67: Rear Wiper/Washer Circuit
2004 Hummer H2
SYSTEM WIRING DIAGRAMS Hummer - H2
2004 ACCESSORIES & EQUIPMENT
Wiring Systems - Hummer H2
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
DIAGNOSTIC INFORMATION AND PROCEDURES
UTILITY/VAN ZONING
All grounds, in-line connectors, pass-through grommets, and splices have identifying numbers that correspond
to where they are located in the vehicle. The following table explains the numbering system.
Application
Specification
Metric
English
BEC Retaining Bolts
9 N.m
80 lb in
Fender Upper Brace Bolts
25 N.m
18 lb ft
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
Fig. 1: Utility/Van Zoning
Courtesy of GENERAL MOTORS CORP.
Utility/Van Zoning
ELECTRICAL SYMBOLS
Electrical Symbols
Callout
Numbers
Zone Description
100-199
Engine compartment (All forward of the dash panel)
001-099 are additional for the engine compartment (Only to be used if all 100-199
items are used)
200-299
Within the instrument panel area
300-399
Passenger compartment (From instrument panel to the rear wheelhouse)
400-499
Luggage compartment (From the rear wheelhouse to the rear of the vehicle
500-599
Within the left front door
600-699
Within the right front door
700-799
Within the left rear door
800-899
Within the right rear door
900-999
Within the liftgate or endgate door
OLD Symbol
NEW Symbol
or
Description
Supplemental Inflatable Restraint (SIR) or Supplemental
Restraint System (SRS) Icon
This icon is used to alert the technician that the system
contains SIR/SRS components that require certain precautions
before servicing.
On-Board Diagnostic (OBD II) Icon
This icon is used to alert the technician that the circuit is
essential for proper OBD II emission controls circuit
operation. Any circuit which, if it fails, causes the malfunction
indicator lamp (MIL) to turn on, is identified as an OBD II
circuit.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
Important Icon
This icon is used to alert the technician that there is additional
information that will aid in servicing a system.
Voltage Indicator Boxes
These boxes are used on schematics to indicate when voltage
is present at a fuse.
Partial Component
When a component is represented in a dashed box, the
component or its wiring is not shown in its entirety.
Entire Component
When a component is represented in a solid box the
component or its wiring is shown in its entirety.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Wiring Systems - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст