Hummer H2. Manual — part 2278
12. Lower the vehicle.
13. Fill the transmission to the proper level with DEXRON(R) III transmission fluid. Refer to Transmission
Fluid Checking Procedure .
ACCUMULATOR ASSEMBLY, SPACER PLATE, AND GASKETS
Tools Required
z
J 25025-B Dial Indicator Post and Guide Pin Set. See Special Tools and Equipment .
z
J 36850 Transjel Lubricant
Removal Procedure
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
Fig. 148: 1-2 Accumulator Cover
Courtesy of GENERAL MOTORS CORP.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the transmission oil pan and filter. Refer to Automatic Transmission Fluid/Filter
Replacement .
3. Remove the control valve body. Refer to Valve Body and Pressure Switch Replacement .
4. Remove the accumulator cover retaining bolts.
5. Remove the 1-2 accumulator cover assembly.
IMPORTANT: The 1-2 accumulator can be removed without removing the control valve
assembly.
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
Fig. 149: Disassembling 1-2 Accumulator
Courtesy of GENERAL MOTORS CORP.
6. Disassemble the 1-2 accumulator.
1. Blow compressed air into the 1-2 accumulator cover, as shown, to remove the 1-2 accumulator
piston.
2. Remove the 1-2 accumulator inner and outer springs.
7. Inspect the 1-2 accumulator inner and outer springs for cracks.
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
Fig. 150: Identifying Accumulator Piston Seal
Courtesy of GENERAL MOTORS CORP.
8. Remove the 1-2 accumulator piston seal (1) from the 1-2 accumulator piston.
9. Inspect the 1-2 accumulator piston for the following defects:
z
Porosity
z
Cracks
z
Scoring
z
Nicks and scratches
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст