Hummer H2. Manual — part 244
SYMPTOMS - STATIONARY WINDOWS
1. Perform the Diagnostic System Check - Defogger before using the symptom tables in order to verify
that all of the following are true:
z
There are no DTCs set.
z
The control modules can communicate via the serial data link.
2. Review the system operation in order to familiarize yourself with the system functions. Refer to Rear
Window Defogger Description and Operation .
Visual/Physical Inspection
z
Inspect for aftermarket devices which could affect the operation of the rear window defogger or the
9
Inspect for poor connections at the harness
connector of the BCM. Refer to Testing for
Intermittent Conditions and Poor Connections
and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 13
Go to Step 12
10
Repair an open or high resistance in ignition voltage
circuit of the DEFOG relay coil. Refer to Wiring
Repairs in Wiring Systems.
Did you complete the repair?
Go to Step 13
-
11
Replace the DEFOG relay.
Did you complete the replacement?
Go to Step 13
-
12
Replace the BCM. Refer to Body Control Module
Replacement in Body Control System.Did you
complete the replacement?
IMPORTANT:
Perform the set up procedure for the Body
Control Module (BCM). Refer to Body Control
Module (BCM) Programming/RPO Configuration
in Body Control System.
Go to Step 13
-
13
1. Use the scan tool in order to clear the DTCs.
2. Operate the vehicle within the Conditions for
Setting the DTC as specified in the supporting
text.
Does the DTC reset?
Go to Step 2
System OK
IMPORTANT: For the inside rearview mirror with the automatic day-night feature, review the
system operation in order to familiarize yourself with the system functions.
Refer to Automatic Day-Night Mirror Description and Operation .
For the rear window defogger system, the following steps must be performed
before using the symptom tables:
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Stationary Windows - Hummer H2
automatic day-night feature of the inside rearview mirror. Refer to Checking Aftermarket Accessories
in Wiring Systems.
z
Inspect the easily accessible or visible system components for obvious damage or conditions which could
cause the symptom.
Intermittent
Faulty electrical connections or wiring may be the cause of intermittent conditions. Refer to Testing for
Intermittent Conditions and Poor Connections in Wiring Systems.
Symptom List
Refer to a symptom diagnostic procedure from the following list in order to diagnose the symptom:
z
Defogger Inoperative - Rear Window
z
Defogger Grid Lines Diagnosis
z
Mirrors - Automatic Day-Night Inoperative
z
Mirrors - Temperature Displays SC or OC
z
Mirrors - Compass Display Inoperative or Inaccurate
z
Mirrors - Temperature Display Inaccurate
DEFOGGER INOPERATIVE - REAR WINDOW
Defogger Inoperative - Rear Window
Step
Action
Yes
No
Schematic Reference:Defogger Schematics
Connector End View Reference:Stationary Windows Connector End Views
1
Did you perform the Defogger Diagnostic System
Check?
Go to Step 2
Go to Diagnostic
System Check -
Defogger
2
1. Start the engine.
2. Depress the rear window defogger switch.
3. Observe the rear window defogger indicator
on the HVAC Control Module.
Does the rear window defogger indicator illuminate?
Go to Step 3
Go to Step 8
3
Connect a test lamp between the left side of the rear
window defogger grid and a good ground.
Does the test lamp illuminate?
Go to Step 4
Go to Step 5
4
Connect a test lamp between the left side of the rear
window defogger grid and the right side of the rear
window defogger grid.
Does the test lamp illuminate?
Go to Testing for
Intermittent Conditions
and Poor Connections in
Wiring Systems
Go to Step 10
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Stationary Windows - Hummer H2
5
1. Turn OFF the ignition.
2. Disconnect the DEFOG relay.
3. Turn ON the ignition, with the engine OFF.
4. Connect a test lamp between the battery
positive voltage circuit of the DEFOG relay
switched input and a good ground.
Does the test lamp illuminate?
Go to Step 6
Go to Step 7
6
1. Connect a 40 amp fused jumper between the
battery voltage circuit of the DEFOG relay
switched input and the relay switched output
to the supply voltage circuit of the rear
window defogger.
2. Connect a test lamp between the left side of
the rear window defogger grid and a good
ground.
Does the test lamp illuminate?
Go to Step 9
Go to Step 12
7
Test the battery positive voltage circuit of the
DEFOG relay switched input for an open or high
resistance. Refer to Circuit Testing and Wiring
Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 15
Go to Step 11
8
Inspect for poor connection at the harness connector
of the HVAC Control Module. Refer to Testing for
Intermittent Conditions and Poor Connections
and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 15
Go to Step 13
9
Inspect for poor connection at the DEFOG relay.
Refer to Testing for Intermittent Conditions and
Poor Connections and Connector Repairs in
Wiring Systems.
Did you find and correct the condition?
Go to Step 15
Go to Step 14
10
Repair an open or high resistance in the ground
circuit of the rear window defogger. Refer to
Wiring Repairs in Wiring Systems.
Did you complete the repair?
Go to Step 15
-
11
Repair a short to ground in the supply voltage circuit
of the rear window defogger. Refer to Wiring
Repairs in Wiring Systems.
Did you complete the repair?
Go to Step 15
-
12
Repair an open or high resistance in the supply
circuit of the rear window defogger. Refer to
Wiring Repairs in Wiring Systems.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Stationary Windows - Hummer H2
DEFOGGER GRID LINES DIAGNOSIS
This test is for reference only. A grid line fault requires the rear window replacement. Refer to Rear Lift
Window Replacement .
1. Start the engine.
2. Activate the rear window defogger system.
3. Connect a test lamp to a good ground.
Did you complete the repair?
Go to Step 15
-
13
Replace the HVAC Control Module. Refer to
HVAC Control Module Replacement in HVAC
Systems - Automatic.
Did you complete the replacement?
Go to Step 15
-
14
Replace the DEFOG relay.
Did you complete the replacement?
Go to Step 15
-
15
Operate the system in order to verify the repair.
Did you correct the condition?
System OK
Go to Step 2
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Stationary Windows - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст