Hummer H2. Manual — part 1902
Fig. 28: Identifying O2 Sensors
Courtesy of GENERAL MOTORS CORP.
8. Remove the oxygen sensors if the catalytic converter is to be replaced.
Installation Procedure
2004 Hummer H2
2004 ENGINE Engine Exhaust - Hummer H2
Fig. 29: Identifying O2 Sensors
Courtesy of GENERAL MOTORS CORP.
1. If the catalytic converter was replaced, perform the following:
1. Apply anti-seize compound GM P/N 12377953 or equivalent to the threads of the old oxygen
sensors.
2. Install the oxygen sensors.
Tighten: Tighten the oxygen sensors to 42 N.m (31 lb ft).
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2004 Hummer H2
2004 ENGINE Engine Exhaust - Hummer H2
Fig. 30: Exhaust Manifold Pipe
Courtesy of GENERAL MOTORS CORP.
2. Install a NEW exhaust seal to the exhaust manifold.
3. Install the catalytic converter.
2004 Hummer H2
2004 ENGINE Engine Exhaust - Hummer H2
Fig. 31: Exhaust Manifold Pipe Nuts (Left)
Courtesy of GENERAL MOTORS CORP.
4. Install the left exhaust manifold pipe nuts.
Tighten: Tighten the exhaust manifold pipe nuts to 50 N.m (39 lb ft).
2004 Hummer H2
2004 ENGINE Engine Exhaust - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст