Hummer H2. Manual — part 2262
Fig. 86: Servo Cover & O-Ring Seal
Courtesy of GENERAL MOTORS CORP.
9. Remove the servo cover and the O-ring seal. If the cover is hung up on the seal, use a pick (2) to pull and
stretch the seal (1) out of the groove. Cut and remove the O-ring seal before removing the cover.
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
Fig. 87: View Of 2-4 Servo
Courtesy of GENERAL MOTORS CORP.
10. Remove the 2-4 servo from the transmission.
11. Inspect the 4th apply piston, 2-4 servo converter, 2nd apply piston, and the servo piston inner housing for
the following defects.
z
Cracks
z
Scoring
z
Burrs and nicks
Installation Procedure
1. Install new seals on the servo pistons and the servo cover.
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
Fig. 88: View Of 2-4 Servo
Courtesy of GENERAL MOTORS CORP.
2. Install the 2-4 servo assembly into the transmission.
3. Install the J 29714-A . See Special Tools and Equipment .
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
Fig. 89: Servo Using J 29714-A
Courtesy of GENERAL MOTORS CORP.
4. Tighten the bolt in order to compress the servo cover.
5. Install the servo cover retaining ring.
6. Remove the J 29714-A from the oil pan flange. See Special Tools and Equipment .
7. Install the oil pan bolt.
Tighten: Tighten the oil pan bolt to 11 N.m (97 lb in).
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2004 Hummer H2
2004 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E (Introduction) - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст