Hummer H2. Manual — part 1104
Installation Procedure
Fig. 31: Battery & Battery Insulator
Courtesy of GENERAL MOTORS CORP.
1. Install the battery insulator, if necessary.
2. Install the battery.
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
3. Install the battery hold down retainer and bolt.
Tighten: Tighten the battery hold down retainer bolt to 25 N.m (18 lb ft).
4. Connect the positive battery cable.
Tighten: Tighten the positive battery cable bolt to 17 N.m (13 lb ft).
Fig. 32: Battery Ground Negative Cable & Bolt
Courtesy of GENERAL MOTORS CORP.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
(Single Battery) .
BATTERY TRAY REPLACEMENT
Removal Procedure
Fig. 33: Battery Tray
Courtesy of GENERAL MOTORS CORP.
1. Remove the battery. Refer to Battery Replacement .
2. Remove the bolts from the battery tray support.
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
3. Remove the battery tray.
Installation Procedure
Fig. 34: Battery Tray
Courtesy of GENERAL MOTORS CORP.
1. Install the battery tray.
Install the bolts to the battery tray support until snug.
NOTE:
Refer to Fastener Notice in Cautions and Notices
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст