Hummer H2. Manual — part 705
Fig. 28: Aligning Windshield
Courtesy of GENERAL MOTORS CORP.
11. Using masking tape in order to mark the locations (1) of the window (2) in the opening.
12. Cut the masking in the center and remove the window from the opening.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Stationary Windows - Hummer H2
Fig. 29: Applying Glass Prep (Clear #1)
Courtesy of GENERAL MOTORS CORP.
13. Use a new dauber in order to apply glass prep clear #1 to the area approximately 10-16 mm (3/8-5/8 in)
around the entire perimeter of the window inner surface.
Immediately wipe the glass primed area using a clean, lint-free cloth.
IMPORTANT: Use care when applying glass prep clear #1 on the window. This primer
dries almost instantly, and may stain the viewing area of the window if not
applied evenly.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Stationary Windows - Hummer H2
Fig. 30: Applying Glass Prep (Clear #1)
Courtesy of GENERAL MOTORS CORP.
14. Apply a second coat of the glass prep clear #1 to the same area of the glass.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Stationary Windows - Hummer H2
Fig. 31: Applying Glass Primer (Black #2)
Courtesy of GENERAL MOTORS CORP.
15. Shake the glass primer black #2 for at least 1 minute.
16. Use a new dauber in order to apply the glass primer black #2 to the same areas (2) that glass prep clear #1
was applied.
17. Allow the glass primer to dry for approximately 10 minutes.
IMPORTANT: The glass primer black #2 is effective up to 8 hours after applying it to the
glass. The primed surface of the glass must be kept clean.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Stationary Windows - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст