Hummer H2. Manual — part 394
Fig. 80: I/P Carrier Center Support Bracket Nut
Courtesy of GENERAL MOTORS CORP.
28. Remove the nut from the I/P carrier center support.
29. Remove the upper I/P carrier bolts.
30. Remove the drivers and passenger side I/P carrier bolts.
31. Disconnect the electrical connections from the body control module (BCM) to the body harness.
32. Remove the wiring harnesses through the openings in the I/P retainer.
33. Remove the I/P assembly from the vehicle.
Installation Procedure
IMPORTANT: Make sure the ambient light sensor is routed to the top of the I/P.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Instrument Panel, Gauges, and Console - Hummer H2
Fig. 81: Aligning I/P & Routing Electrical Harnesses
Courtesy of GENERAL MOTORS CORP.
1. Align the I/P in the vehicle and route all electrical harnesses through the I/P retainer.
2. Install the upper and side I/P carrier bolts.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Instrument Panel, Gauges, and Console - Hummer H2
Fig. 82: I/P Carrier Center Support Bracket Nut
Courtesy of GENERAL MOTORS CORP.
3. Install the I/P carrier center support nut.
Tighten: Tighten the nut to 9 N.m (80 lb in).
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Instrument Panel, Gauges, and Console - Hummer H2
Fig. 83: Windshield Garnish Moldings
Courtesy of GENERAL MOTORS CORP.
4. Install the windshield garnish moldings. Refer to Garnish Molding Replacement - Windshield Pillar .
5. Install the upper HVAC air temperature sensors from the HVAC ducts. Refer to Air Temperature
Sensor Replacement - Upper Right and Air Temperature Sensor Replacement - Upper Left in
HVAC Systems - Automatic.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Instrument Panel, Gauges, and Console - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст