Toyota Tundra. Manual — part 1989
a
Remove the exhaust manifold RH (see REMOVAL )
2
REMOVE CAMSHAFTS (for Bank 2)
a
Remove the camshafts (see REMOVAL )
3
REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
a
Remove the 16 valve rocker arms from the cylinder head
HINT:
Arrange the removed parts in the correct order
4
REMOVE VALVE LASH ADJUSTER ASSEMBLY
a
Remove the 16 valve lash adjusters from the cylinder head
HINT:
Arrange the removed parts in the correct order
5
REMOVE VALVE STEM CAP
a
Remove the 16 valve stem caps from the cylinder head
HINT:
Arrange the removed parts in the correct order
6
REMOVE CYLINDER HEAD SUB-ASSEMBLY RH
a
Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
Fig. 26: Identifying Cylinder Head Sub-Assembly RH Bolts Loosening Sequence
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 cylinder head bolts in the sequence
shown in the illustration Remove the 10 cylinder head bolts and plate washers
HINT:
Be sure to arrange the removed parts for each installation position separately
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
NOTE:
Be careful not to drop washers into the cylinder head.
Head warpage or cracking could result from removing bolts in an
incorrect order.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
7
REMOVE CYLINDER HEAD GASKET RH
INSTALLATION
1
INSPECT CYLINDER HEAD SET BOLT (See INSPECTION )
2
INSPECT CYLINDER HEAD SUB-ASSEMBLY RH (See INSPECTION )
3
INSTALL CYLINDER HEAD GASKET RH
a
Check the piston protrusions for each cylinder
1
Clean the cylinder block with solvent
2
Set the piston of the cylinder to be measured to slightly ATDC
b
Place the cylinder head gasket on the cylinder block surface with the front face of the Lot No
stamp upward
Fig. 27: Identifying Cylinder Head Sub-Assembly RH Bolts Loosening
Sequence
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NOTE:
Be careful of the installation direction.
Make sure that no oil is on the front end (indicated by the arrows) of the
cylinder head gasket.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст