Toyota Tundra. Manual — part 1751
Fig. 94: Inspecting Purge VSV
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
If the result is not as specified, replace the purge VSV
b
Inspect the purge VSV operation
1
Check that air does not flow from ports
Fig. 95: Inspecting Purge VSV
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2
Apply battery voltage across the terminals
3
Check that air flows from ports
If the result is not as specified, replace the purge VSV
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FBE) - Tundra
Fig. 96: Checking Air Flows Of Ports
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSTALLATION
1
INSTALL PURGE VSV
a
Install the purge VSV with the bolt
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
Fig. 97: Locating Purge VSV With Bolt
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Connect the connector
2
CONNECT PURGE LINE HOSE
a
Connect the 2 hoses
HINT:
Turn the claw of the clip to the upper side
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FBE) - Tundra
3
INSTALL V-BANK COVER (See INSTALLATION )
FUEL TANK CAP
INSPECTION
1
INSPECT FUEL TANK CAP ASSEMBLY
a
Visually check if the cap and/or gasket are deformed or damaged
If the result is not as specified, replace the fuel tank cap assembly or gasket
Fig. 98: Inspecting Fuel Tank Cap Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
PCV VALVE
COMPONENTS
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FBE) - Tundra
Fig. 99: Identifying PCV Valve Components With Torque Specification
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1
REMOVE INTAKE MANIFOLD
a
Remove the intake manifold (See REMOVAL )
2
REMOVE NO. 2 ENGINE COVER (See REMOVAL )
3
DISCONNECT PCV VALVE HOSE
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FBE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст