Toyota Tundra. Manual — part 1294
Fig. 371: Identifying Heated Oxygen Sensor Replacement Components With Torque Specification (1 Of
2)
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Fig. 372: Identifying Heated Oxygen Sensor Replacement Components With Torque Specification (2 Of
2)
ON-VEHICLE INSPECTION
1. INSPECT HEATED OXYGEN SENSOR
a. Disconnect the 2 sensor connectors.
b. Measure the resistance according to the value (s) in the table below.
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Standard resistance (for Bank 1 sensor 2)
TESTER CONNECTION SPECIFIED CONDITION
Standard resistance (for Bank 2 sensor 2)
TESTER CONNECTION SPECIFIED CONDITION
If the result is not as specified, replace the sensor.
c. Connect the 2 sensor connectors.
Fig. 373: Identifying Heated Oxygen Sensor Connector Terminals
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY (for Regular Cab Standard Deck)
Tester Connection Condition Specified Condition
1 (HT1B) - 2 (+B) 20°C (68°F)
11 to 16 ohms
Tester Connection Condition Specified Condition
1 (HT2B) - 2 (+B) 20°C (68°F)
11 to 16 ohms
NOTE:
Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and settings. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
(See REMOVAL )
3. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for Regular Cab Standard Deck) (See
REMOVAL )
4. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (except Regular Cab Standard Deck) (See
REMOVAL )
5. REMOVE FRONT EXHAUST PIPE ASSEMBLY (See REMOVAL )
6. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
a. Using SST, remove the sensor.
SST 09224-00010
Fig. 374: Removing Heated Oxygen Sensor (Bank 1 Sensor 2)
7. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
a. Using SST, remove the sensor.
SST 09224-00010
Fig. 375: Removing Heated Oxygen Sensor (Bank 2 Sensor 2)
INSTALLATION
1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
a. Using SST, install the sensor.
Torque: without SST
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст