Toyota Tundra. Manual — part 2407
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to Next Step
2. CHECK AIR CONDITIONING AMPLIFIER
a. Reconnect the J19 air conditioning amplifier connector.
Fig. 65: Identifying Terminals Of J19 Air Conditioning Amplifier Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Measure the resistance and voltage according to the value(s) in the table below.
Standard Resistance
TESTER CONNECTION SPECIFIED CONDITION CHART
Standard Voltage
TESTER CONNECTION SPECIFIED CONDITION CHART
NG: REPLACE AIR CONDITIONING AMPLIFIER (See REMOVAL )
OK: Go to Next Step
3. REPAIR OR REPLACE AIR CONDITIONING HARNESS
Tester Connection
Condition Specified Condition
J19-14 (GND) - Body ground Always
Below 1 ohms
Tester Connection
Condition Specified Condition
J19-14 (GND) - z1-2 (BUS G) Always
Below 1 ohms
Tester Connection
Condition Specified Condition
z1-4 (B BUS) - z1-2 (BUS G) Always
11 to 14 V
2009 Toyota Tundra
2009 HVAC Air Conditioning - Tundra
a. Repair or replace the air conditioning harness.
4. CHECK FOR DTC
a. Clear the DTC (see DTC CHECK/CLEAR ).
b. Check for DTC (see DTC CHECK/CLEAR ).
OK:
DTC is not output.
NG: REPLACE AIR CONDITIONING AMPLIFIER (See REMOVAL )
OK: END
DTC B1499/99 MULTIPLEX COMMUNICATION CIRCUIT
DESCRIPTION
This DTC outputs when CAN communication error is occurred.
DTC DETECTION CONDITION CHART
INSPECTION PROCEDURE
1. CHECK FOR DTC
a. Clear the DTC (see DTC CHECK/CLEAR ).
b. Check for the DTC (see DTC CHECK/CLEAR ).
Result
RESULT REFERENCE
B: USE SIMULATION METHOD TO CHECK (See HOW TO PROCEED WITH
TROUBLESHOOTING )
A: GO TO CAN COMMUNICATION SYSTEM (See PRECAUTION )
BLOWER MOTOR CIRCUIT
DESCRIPTION
DTC
DTC Detection Condition
Trouble Area
B1499/99
Open in CAN communication
circuit
CAN communication system
Result
Proceed to
DTC B1499/99 is output
A
DTC B1499/99 is not output
B
2009 Toyota Tundra
2009 HVAC Air Conditioning - Tundra
The blower motor is operated by signals from the air conditioning amplifier. Blower motor speed signals are
transmitted by changes in the duty ratio.
Duty Ratio:
Fig. 66: Blower Motor Level Graph
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
The duty ratio is the ratio of the blower motor OFF time (B) to the total of the blower motor ON and OFF time
(A + B).
The blower motor controller controls the blower motor speed.
WIRING DIAGRAM
2009 Toyota Tundra
2009 HVAC Air Conditioning - Tundra
Fig. 67: Blower Motor - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. PERFORM ACTIVE TEST USING TECHSTREAM (BLOWER MOTOR)
a. Select the Active Test, using the Techstream to generate a control command, and then check that
the blower motor operates.
Air Conditioner
ACTIVE TEST REFERENCE
Result
RESULT REFERENCE
B: Go to step 5
C: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE (See PROBLEM SYMPTOMS TABLE )
A: Go to Next Step
Tester Display
Test Part
Control Range Diagnostic Note
Blower Motor Blower motor Min.: 0, Max.: 31
-
Result
Proceed to
NG (blower motor does not operate)
A
NG (blower motor operates but does not change speed)
B
OK
C
2009 Toyota Tundra
2009 HVAC Air Conditioning - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст