Toyota Tundra. Manual — part 1268
TESTER CONNECTION SPECIFIED CONDITION
Standard resistance (Check for short)
TESTER CONNECTION SPECIFIED CONDITION
b. Check the harness and connectors between the integration relay and body ground.
1. Measure the resistance according to the value (s) in the table below.
Standard resistance (Check for open)
TESTER CONNECTION SPECIFIED CONDITION
NG : REPAIR OR REPLACE HARNESS OR CONNECTOR
Tester Connection
Condition Specified Condition
A24-34 (MREL) - 1B-2 Always
Below 1 ohms
A24-3 (+B) - 1B-4
Always
Below 1 ohms
A24-2 (+B2) - 1B-4
Always
Below 1 ohms
Tester Connection
Condition Specified Condition
A24-34 (MREL) or 1B-2 - Body ground Always
10 kohms or higher
A24-3 (+B) or 1B-4 - Body ground
Always
10 kohms or higher
A24-2 (+B2) or 1B-4 - Body ground
Always
10 kohms or higher
Tester Connection Condition Specified Condition
1B-3 - Body ground Always
Below 1 ohms
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Fig. 261: Checking Harness & Connector (+B, +B2 & MREL Circuit)
OK : Go to next step.
4. CHECK HARNESS AND CONNECTOR (ECM - BODY GROUND)
a. Disconnect the D74 ECM connector.
b. Measure the resistance according to the value (s) in the table below.
Standard resistance (Check for open)
TESTER CONNECTION SPECIFIED CONDITION
Tester Connection
Condition Specified Condition
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
NG : REPAIR OR REPLACE HARNESS OR CONNECTOR
Fig. 262: Identifying D74 ECM Connector Terminals
OK : Go to next step.
5. INSPECT ECM (IGSW VOLTAGE)
a. Disconnect the D74 and A24 ECM connectors.
b. Measure the voltage according to the value (s) in the table below.
Standard voltage
TESTER CONNECTION SPECIFIED CONDITION
NG : Go to step 6
D74-81 (E1) - Body ground Always
Below 1 ohms
Tester Connection
Switch Condition Specified Condition
A24-28 (IGSW) - D74-81 (E1) Ignition switch ON
11 to 14 V
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Fig. 263: Identifying D74 & A24 ECM Connectors Terminals
OK : REPLACE ECM (See REMOVAL )
6. INSPECT FUSE (IGN)
a. Remove the IGN fuse from the engine room relay block.
b. Measure the resistance according to the value (s) in the table below.
Standard resistance (Check for open)
TESTER CONNECTION SPECIFIED CONDITION
NG : CHECK FOR SHORT IN ALL HARNESSES AND CONNECTORS CONNECTED TO
FUSE AND REPLACE FUSE
Tester Connection Condition Specified Condition
IGN fuse
Always
Below 1 ohms
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст