Toyota Tundra. Manual — part 295
Fig. 106: Identifying J88 No. 2 Junction Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: Go to step 24
OK: Go to next step
21. CHECK FOR SHORT IN CAN BUS WIRES (NO. 2 JUNCTION CONNECTOR - ECM)
a. Disconnect the J92 No. 2 junction connector connector.
b. Measure the resistance according to the value(s) in the table below.
Result
RESULT REFERENCE TABLE
Tester Connection
Switch Condition Measured Resistance Proceed to
J92-1 (CANH) - J92-2 (CANL) Ignition switch OFF
1 ohms or higher
OK
Below 1 ohms
NG
2009 Toyota Tundra
2009 ACCESSORIES & EQUIPMENT CAN Communication - Tundra
Fig. 107: Identifying J92 No. 2 Junction Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: Go to step 25
OK: REPAIR OR REPLACE NO. 2 JUNCTION CONNECTOR
22. CHECK FOR SHORT IN CAN BUS WIRES (AIR CONDITIONING AMPLIFIER)
a. Disconnect the J19 air conditioning amplifier connector.
b. Measure the resistance according to the value(s) in the table below.
Result
RESULT REFERENCE TABLE
Tester Connection
Switch Condition Measured Resistance Proceed to
J85-1 (CANH) - J85-2 (CANL) Ignition switch OFF
1 ohms or higher
OK
Below 1 ohms
NG
2009 Toyota Tundra
2009 ACCESSORIES & EQUIPMENT CAN Communication - Tundra
Fig. 108: Identifying J85 No. 2 Junction Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO AIR CONDITIONING
AMPLIFIER (CANH, CANL)
OK: REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (See AIR CONDITIONING
AMPLIFIER )
23. CHECK FOR SHORT IN CAN BUS WIRES (BUS BUFFER ECU)
a. Disconnect the J59 bus buffer ECU connector.
b. Measure the resistance according to the value(s) in the table below.
Result
RESULT REFERENCE TABLE
Tester Connection
Switch Condition Measured Resistance Proceed to
J98-1 (CANH) - J98-2 (CANL) Ignition switch OFF
1 ohms or higher
OK
Below 1 ohms
NG
2009 Toyota Tundra
2009 ACCESSORIES & EQUIPMENT CAN Communication - Tundra
Fig. 109: Identifying J98 No. 2 Junction Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO BUS BUFFER ECU
(CANH, CANL)
OK: REPLACE BUS BUFFER ECU
24. CHECK FOR SHORT IN CAN BUS WIRES (4WD CONTROL ECU)
a. Disconnect the A25 4WD control ECU connector.
b. Measure the resistance according to the value(s) in the table below.
Result
RESULT REFERENCE TABLE
Tester Connection
Switch Condition Measured Resistance Proceed to
J88-1 (CANH) - J88-2 (CANL) Ignition switch OFF
1 ohms or higher
OK
Below 1 ohms
NG
2009 Toyota Tundra
2009 ACCESSORIES & EQUIPMENT CAN Communication - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст