Toyota Tundra. Manual — part 262
STEERING PAD SWITCH
COMPONENTS
Fig. 448: Identifying Steering Pad Switch Components
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
CAUTION: Wait at least 90 seconds after disconnecting the cable from the
negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
2. REMOVE LOWER NO. 2 STEERING WHEEL COVER (See REMOVAL )
3. REMOVE LOWER NO. 3 STEERING WHEEL COVER (See REMOVAL )
4. REMOVE STEERING PAD (See REMOVAL )
5. REMOVE STEERING PAD SWITCH ASSEMBLY
a. Disconnect the connector.
b. Remove the 2 screws.
c. Detach the 4 pins and remove the steering pad switch.
Fig. 449: Identifying Steering Pad Switch Pins
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION
1. INSPECT STEERING PAD SWITCH ASSEMBLY
NOTE:
Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and settings. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Fig. 450: Identifying Steering Pad Switch Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
a. Measure the resistance according to the value(s) in the table below.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITION
If the result is not as specified, replace the steering pad switch assembly.
INSTALLATION
1. INSTALL STEERING PAD SWITCH ASSEMBLY
a. Attach the 4 pins to install the switch with the 2 screws.
b. Connect the connector.
2. INSTALL LOWER NO. 3 STEERING WHEEL COVER (See INSTALLATION )
3. INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION )
Tester Connection
Switch Condition
Specified Condition
9 (AU2) - 8 (EAU)
No switch is pushed
100 kohms or higher
MODE switch pushed
Below 1 ohms
On Hook switch pushed
329 ohms
Off Hook switch pushed
1000 ohms
Voice switch is pushed
3110 ohms
10 (AU1)-8(EAU)
No switch is pushed
100 kohms or higher
Seek* switch pushed
Below 1 ohms
Seek- switch pushed
329 ohms
Volume* switch is pushed
1000 ohms
Volume- switch Is pushed
3110 ohms
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
4. INSTALL STEERING PAD (See INSTALLATION )
Fig. 451: Identifying Steering Pad Switch Pins
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INSPECT STEERING PAD (See INSTALLATION )
7. CHECK SRS WARNING LIGHT (See INSTALLATION )
MICROPHONE AMPLIFIER
COMPONENTS
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст