Toyota Tundra. Manual — part 1707
2
REMOVE FRONT FENDER LINER RH
a
Remove the 9 clips and fender liner
Fig. 15: Identifying Fender Liner Clips
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3
REMOVE NO. 3 AIR INJECTION SYSTEM HOSE
a
Using a clip remover, remove the 2 clips
b
Fold back the fender apron seal
Fig. 16: Identifying Fender Apron Seal Clips
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c
Disconnect the 2 connectors
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and settings. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
2009 Toyota Tundra
2009 ENG NE Emission Control (1GR-FE) - Tundra
Fig. 17: Identifying Connectors
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
d
Disconnect the 2 connector clamps
e
Detach the 2 clamps
Fig. 18: Identifying Clamps
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
f
Detach the 2 bracket clips and remove the No 3 air injection system hose
4
REMOVE NO. 2 AIR INJECTION SYSTEM HOSE
a
Detach the bracket clip and remove the No 2 air injection system hose
2009 Toyota Tundra
2009 ENG NE Emission Control (1GR-FE) - Tundra
Fig. 19: Identifying No. 2 And 3 Air Injection System Hoses, Bracket And Clips
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
5
REMOVE AIR PUMP ASSEMBLY
a
Remove the 2 bolts, 2 nuts and air pump
Fig. 20: Identifying Air Pump Assembly And Fasteners
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
DISASSEMBLY
1
REMOVE AIR PUMP INLET
a
Remove the 2 bolts and air pump inlet
2009 Toyota Tundra
2009 ENG NE Emission Control (1GR-FE) - Tundra
Fig. 21: Identifying Air Pump Inlet Tube And Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2
REMOVE NO. 1 AIR INJECTION SYSTEM HOSE
a
Remove the 2 air injection system hoses
3
REMOVE AIR PUMP
a
Detach the 2 clamps and remove the 6 air pump insulators and 2 pumps from the bracket
Fig. 22: Identifying Clamps And Air Pump Insulators And Pumps
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION
1
INSPECT AIR PUMP
a
Measure the resistance according to the value(s) in the table below
Standard resistance
AIR PUMP STANDARD RESISTANCE
Tester Connection Condition Specified Condition
1 - 2
20°C (68°F)
0 4 to 1 0 ohms
1 - Body ground
Always
10 kohms or higher
2 - Body ground
2009 Toyota Tundra
2009 ENG NE Emission Control (1GR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст