Toyota Tundra. Manual — part 1265
Fig. 252: Identifying R1 Canister Pump Module Connector Terminals
Result
RESULT CHART
B : Go to step 24
A : Go to next step.
23. CHECK HARNESS AND CONNECTOR (CANISTER PUMP MODULE - BODY GROUND)
a. Turn the ignition switch OFF.
Test Result
Suspected Trouble Area
Proceed
To
Below 3 V when OFF
11 to 14 V when ON
1. Wire harness between leak detection pump and body
ground
2. Leak detection pump
A
Below 3 V when OFF and
ON
1. Wire harness between leak detection pump and
ECM
2. ECM
B
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
b. Disconnect the R1 canister pump module connector.
c. Check the resistance between the MGND terminal of the canister pump module connector and the
body ground.
Fig. 253: Identifying R1 Canister Pump Module Connector Terminals
Result
RESULT CHART
A : Go to step 29
B : Go to step 31
24. CHECK HARNESS AND CONNECTOR (ECM - CANISTER PUMP MODULE)
a. Turn the ignition switch OFF.
b. Disconnect the A24 ECM connector.
Test Result
Suspected Trouble Area
Proceed To
Below 1 ohms
Leak detection pump
A
10 kohms or higher Wire harness between canister pump module and body ground B
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
c. Disconnect the R1 canister pump module connector.
d. Measure the resistance between MPMP terminal of the ECM connector and MTRB terminal of the
canister pump module connector.
Fig. 254: Identifying A24 ECM Connector & R1 Canister Pump Module Connector
Terminals
Result
RESULT CHART
A : Go to step 34
B : Go to step 31
25. INSPECT INTAKE MANIFOLD (EVAP PURGE PORT)
a. Stop the engine.
b. Disconnect the EVAP hose from the intake manifold.
c. Start the engine.
d. Use your finger to confirm that the port of the intake manifold has suction.
Result
Test Result
Suspected Trouble Area
Proceed To
Below 1 ohms
ECM
A
10 kohms or higher Wire harness between ECM and canister pump module B
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
RESULT CHART
A : Go to step 32
B : Go to step 33
26. CORRECTLY REINSTALL OR REPLACE FUEL TANK CAP
HINT:
When reinstalling the fuel tank cap, tighten it until a few click sounds are heard.
When replacing the fuel tank cap, use a fuel tank cap that meets OEM specifications, and install it
until a few click sounds are heard.
NEXT : Go to step 36
27. REPLACE FUEL TANK CAP
HINT:
When replacing the fuel cap, use a fuel cap that meets OEM specifications, and install it until a few click
sounds are heard.
NEXT : Go to step 36
28. LOCATE EVAP LEAK PART
Test Result
Suspected Trouble Area
Proceed To
Suction applied EVAP hose between intake manifold and purge VSV
A
No suction
Intake manifold
B
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст