Toyota Tundra. Manual — part 1434
c. Turn the ignition switch to ON.
d. Measure the voltage according to the value(s) in the table below.
Standard voltage
STANDARD VOLTAGE SPECIFICATION
D54-1 (E2) - Body ground Always
Below 1 ohms
Tester Connection
Switch Condition
Specified Condition
D48-1 (BATT) - Body ground Ignition switch ON 11 to 14 V (near battery voltage)
D50-5 (+B) - Body ground
Ignition switch ON 11 to 14 V (near battery voltage)
D52-1 (BAT2) - Body ground Ignition switch ON 11 to 14 V (near battery voltage)
D54-5 (+B2) - Body ground
Ignition switch ON 11 to 14 V (near battery voltage)
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 239: Identifying D48, D50 Or D52 & D54 AID Connectors
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
NG : REPAIR OR REPLACE AIR INJECTION CONTROL DRIVER POWER SOURCE
CIRCUIT
OK : Go to Next Step
9. CHECK HARNESS AND CONNECTOR (ECM - AIR INJECTION CONTROL DRIVER)
a. Disconnect the D74 ECM connector.
b. Disconnect the D50 or D54 AID connector.
c. Measure the resistance according to the value(s) in the table below.
Standard resistance
STANDARD RESISTANCE SPECIFICATION
Tester Connection
Condition Specified Condition
D74-54 (AIRP) - D50-4 (SIP)
Always
Below 1 ohms
D74-53 (ARP2) - D54-4 (SIP2) Always
Below 1 ohms
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 240: Identifying D74 ECM & D50 Or D54 AID Connector
NG : REPAIR OR REPLACE HARNESS OR CONNECTOR
OK : Go to Next Step
10. REPLACE AIR INJECTION CONTROL DRIVER
a. Replace the air injection control driver. (See AIR INJECTION DRIVER ).
11. CHECK WHETHER DTC OUTPUT RECURS (DTC P2444, P2445, P2446 AND/OR P2447)
a. Start the engine and warm it up.
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст