Toyota Tundra. Manual — part 1375
Fig. 134: Waveform Graph
Reference: Inspection using an oscilloscope.
While cranking or idling the engine, check the waveform between terminals IGT (1 to 8) and E1, and IGF1 or
IGF2 and E1 of the ECM connector.
WAVEFORM REFERENCE
MONITOR DESCRIPTION
P0354
P0355
P0356
P0357
P0358
No IGF signal to ECM while engine
running (1 trip detection logic)
between ignition coil with igniter and ECM
No. 1 to No. 8 ignition coils with igniters
ECM
Item
Content
Terminal
CH1: IGT1, IGT2, IGT3, IGT4, IGT5, IGT6, IGT7, IGT8 - E1 CH2: IGF1, IGF2 - E1
Equipment Setting
2 V/DIV.
20 msec./DIV.
Condition
Cranking or idling
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 135: Ignition Confirmation Signal
If the ECM does not receive any IGF signals despite transmitting the IGT signal, it interprets this as a fault in
the igniter and sets a DTC.
If the malfunction is not repaired successfully, a DTC is set 1 second after the engine is next started.
MONITOR STRATEGY
MONITOR STRATEGY
TYPICAL ENABLING CONDITIONS
Related DTCs
P0351: Igniter (cylinder 1) malfunction
P0352: Igniter (cylinder 2) malfunction
P0353: Igniter (cylinder 3) malfunction
P0354: Igniter (cylinder 4) malfunction
P0355: Igniter (cylinder 5) malfunction
P0356: Igniter (cylinder 6) malfunction
P0357: Igniter (cylinder 7) malfunction
P0358: Igniter (cylinder 8) malfunction
Required Sensors/Components (Main)
Igniter
Required Sensors/Components (Related)
Crankshaft position sensor
Frequency of Operation
Continuous
Duration
About 1 second
MIL Operation
Immediate
Sequence of Operation
None
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
TYPICAL ENABLING CONDITIONS
TYPICAL MALFUNCTION THRESHOLDS
TYPICAL MALFUNCTION THRESHOLDS
COMPONENT OPERATING RANGE
COMPONENT OPERATING RANGE
WIRING DIAGRAM
Monitor runs whenever following DTCs not present
None
Either of following conditions A or B met
-
A. Engine RPM
1500 RPM or less
B. Starter
OFF
Either of following conditions C or D met
-
C. Both of following conditions (a) and (b) met
-
(a) Engine speed
500 RPM or less
(b) Battery voltage
6 V or higher
D. All of following conditions (a), (b) and (c) met
-
(a) Engine speed
More than 500 RPM
(b) Battery voltage
10 V or higher
(c) Number of sparks after CPU reset
5 sparks or more
IGF signal ECM does not receive any IGF signal despite ECM sending IGT signal to igniter
IGF signal
Igniter transmits IGF signal when it receives IGT signal from ECM
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 136: Ignition Coil - Wiring Diagram (1 Of 2)
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст