Toyota Tundra. Manual — part 311
a. Disconnect the A25 4WD control ECU connector.
b. Reconnect the cable to the negative (-) battery terminal.
c. Select "CAN Bus Check" on the Techstream.
Result
RESULT REFERENCE
B: Go to step 14
A: Go to next step
13. CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (4WD CONTROL ECU BRANCH
WIRE)
a. Measure the resistance according to the value(s) in the table below.
Standard resistance
STANDARD RESISTANCE SPECIFICATION TABLE
Fig. 165: Identifying A25 4WD Control ECU Connector
NOTE:
For vehicles without 4WD, go to step 14.
Result
Proceed
to
Four Wheel Drive Control not displayed on Techstream.
A
Several ECUs and sensors other than Four Wheel Drive Control not displayed on
Techstream.
B
Tester Connection
Switch Condition Specified Condition
A25-19 (CANH) - A25-20 (CANL) Ignition switch OFF
54 to 69 ohms
2009 Toyota Tundra
2009 ACCESSORIES & EQUIPMENT CAN Communication - Tundra
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE CAN BRANCH WIRE OR CONNECTOR (4WD CONTROL ECU)
OK: REPLACE 4WD CONTROL ECU (See REMOVAL )
14. CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (AIR CONDITIONING
AMPLIFIER BRANCH WIRE)
a. Disconnect the J19 air conditioning amplifier connector.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
STANDARD RESISTANCE SPECIFICATION TABLE
Fig. 166: Identifying J19 Air Conditioning Amplifier Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE CAN BRANCH WIRE OR CONNECTOR (AIR CONDITIONING
AMPLIFIER)
OK: REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (See AIR CONDITIONING
AMPLIFIER )
Tester Connection
Switch Condition Specified Condition
J19-11 (CANH) - J19-12 (CANL) Ignition switch OFF
54 to 69 ohms
2009 Toyota Tundra
2009 ACCESSORIES & EQUIPMENT CAN Communication - Tundra
2009 ACCESSORIES AND EQUIPMENT
Cruise Control - Tundra
CRUISE CONTROL SYSTEM
PRECAUTION
1. HANDLING PRECAUTION FOR CRUISE CONTROL SYSTEM
a. Turn the cruise control main switch OFF when not using the cruise control system.
b. Be careful as the vehicle speed increases when driving downhill with the cruise control system on.
c. The RESUME / ACCEL operation changes according to the cruise control system status. When the
cruise control system is operating, ACCEL operates. When the cruise control system is not
operating, RESUME operates.
d. When the cruise control system is operating and the CRUISE main indicator light blinks, turn the
cruise control main switch OFF to reset the cruise control system. After the reset, if the cruise
control main switch cannot be turned ON, or the cruise control system is canceled immediately
after turning the cruise control main switch ON, the system may have a malfunction.
e. Do not use the cruise control system where the road conditions are as follows:
Heavy traffic
Steep decline
Roads with sharp turns
Icy or snowy roads
Slippery roads
PARTS LOCATION
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Cruise Control - Tundra
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Cruise Control - Tundra
Fig. 1: Identifying Cruise Control System Components Location (1 Of 2)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Cruise Control - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст