Toyota Tundra. Manual — part 2779
Standard Resistance
TESTER CONNECTION SPECIFIED CONDITION TABLE
Fig. 39: Identifying J31 ECU Connector (2 Of 2)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPLACE FUSE AND REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE FUSE
TC AND CG TERMINAL CIRCUIT
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are indicated by the
blinking of the tire pressure warning light.
WIRING DIAGRAM
Tester Connection
Condition Specified Condition
J31-7 (IG) - Body ground Always
10 kohms or higher
2009 Toyota Tundra
2009 SUSPENSION Tire & Wheel - Tundra
Fig. 40: TC & CG Terminal - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
HINT:
When each warning light continues blinking, a ground short in the wiring of terminal TC of the DLC3 or an
internal ground short in each ECU is suspected.
INSPECTION PROCEDURE
1. CHECK HARNESS AND CONNECTOR (DLC3 - ECU AND BODY GROUND)
a. Disconnect the J31 ECU connector.
b. Measure the resistance according to the value(s) in the table below.
Standard Resistance
TESTER CONNECTION SPECIFIED CONDITION TABLE
NOTE:
When replacing the tire pressure warning ECU, read the transmitter IDs
stored in the old ECU using the Techstream and write them down before
removal.
It is necessary to perform INITIALIZATION after REGISTRATION of the
transmitter IDs into the tire pressure warning ECU after the ECU and/or tire
pressure warning valve and transmitter has been replaced.
Tester Connection
Condition Specified Condition
J31-3 (TC) - J17-13 (TC)
Always
Below 1 ohms
J31-3 (TC) - Body ground
Always
10 kohms or higher
J17-4 (CG) - Body ground Always
Below 1 ohms
2009 Toyota Tundra
2009 SUSPENSION Tire & Wheel - Tundra
Fig. 41: Identifying J31 ECU Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG : REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: CHECK ECU POWER SOURCE CIRCUIT (See ECU POWER SOURCE CIRCUIT )
TIRE PRESSURE WARNING RECEIVER
COMPONENTS
2009 Toyota Tundra
2009 SUSPENSION Tire & Wheel - Tundra
Fig. 42: Identifying Tire Pressure Warning Receiver Replacement Components With Torque
Specifications
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1. REMOVE ROOF HEADLINING ASSEMBLY
a. for Regular Cab:
Remove the roof headlining (see COMPONENTS ).
b. for Double Cab:
Remove the roof headlining (see REMOVAL ).
2009 Toyota Tundra
2009 SUSPENSION Tire & Wheel - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст