Toyota Tundra. Manual — part 2294
Fig. 35: Identifying Oil Pump Components With Torque Specifications
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1
DISCHARGE FUEL SYSTEM PRESSURE (See REMOVAL )
2
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable some systems need to be initialized
2009 Toyota Tundra
2009 ENGINE Lubrication (3UR-FBE) - Tundra
3
DRAIN ENGINE OIL (See REPLACEMENT )
4
DRAIN ENGINE COOLANT (See COOLANT )
5
REMOVE RADIATOR ASSEMBLY
a
Remove the radiator (See REMOVAL )
6
REMOVE AIR CLEANER HOSE ASSEMBLY (See REMOVAL )
7
REMOVE AIR CLEANER ASSEMBLY (See REMOVAL )
8
DISCONNECT ENGINE WIRE
a
Engine Room LH Side:
1
Remove the engine room relay block cover
2
Disconnect the 2 connectors and detach the 2 clamps from the engine room junction block
Fig. 36: Locating Connectors And Clamps On Engine Room Junction Block
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3
Disconnect the 4 air injection control driver connectors
Fig. 37: Locating Air Injection Control Driver Connectors
after the cable is reconnected (See INITIALIZATION ).
After the ignition switch is turned off, the navigation system requires
approximately 90 seconds to record various types of memory and
settings. As a result, after turning the ignition switch off, wait 90
seconds or more before disconnecting the cable from the negative (-)
battery terminal.
2009 Toyota Tundra
2009 ENGINE Lubrication (3UR-FBE) - Tundra
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
4
Disconnect the 2 wire harness clamps
Fig. 38: Locating Wire Harness Clamps
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
5
Disconnect the injector connector
6
Disconnect the 4 ignition coil connectors
7
Disconnect the 2 VVT sensor connectors
8
Disconnect the 4 clamps
9
Remove the 2 bolts and ground wire
10
Disconnect the noise filter connector
Fig. 39: Locating Ignition Coil, VVT Sensor And Noise Filter Connectors (LH)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
11
Disconnect the engine coolant temperature sensor connector
12
Disconnect the 2 camshaft timing oil control valve connectors
13
Disconnect the camshaft position sensor connector
14
Disconnect the 3 clamps
15
Disconnect the cooler compressor connector
2009 Toyota Tundra
2009 ENGINE Lubrication (3UR-FBE) - Tundra
Fig. 40: Locating Engine Coolant Temperature Sensor And Camshaft Timing Oil
Control Valve Connectors
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Engine Room RH Side:
1
Disconnect the 2 camshaft timing oil control valve connectors
2
Disconnect the 4 ignition coil connectors
3
Disconnect the injector connector
4
Disconnect the 2 VVT sensor connectors
5
Disconnect the noise filter connector
6
Remove the 2 bolts and ground wire
7
Disconnect the 2 air pump connectors
8
Disconnect the throttle position sensor and throttle control motor connector
9
Disconnect the 5 clamps
2009 Toyota Tundra
2009 ENGINE Lubrication (3UR-FBE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст