Toyota Tundra. Manual — part 419
SLIP indicator light:
SLIP INDICATOR LIGHT FAIL-SAFE CHART
TAIL indicator light:
TAIL INDICATOR LIGHT FAIL-SAFE CHART
Tire pressure warning light:
TIRE PRESSURE WARNING LIGHT FAIL-SAFE CHART
A/T OIL TEMP warning light:
Condition
Fail-safe Operation
Fail-safe
Deactivation
Condition
Headlight LO on request signal is
interrupted for 10 seconds during CAN
bus wake-up mode
Ignition switch is ON: HEAD
indicator light condition is
maintained
Ignition switch is OFF: HEAD
indicator light is off
Normal data is
received
Condition
Fail-safe Operation
Fail-safe
Deactivation
Condition
Frame data (including SLIP indicator
on/blink request signal) is interrupted for 0.9
seconds
SLIP indicator light condition is
maintained until ignition switch
OFF
Normal data is
received
Condition
Fail-safe Operation
Fail-safe
Deactivation
Condition
Taillight on request signal is interrupted
for 10 seconds during CAN bus wake-up
mode
Ignition switch is ON: TAIL
indicator light condition is
maintained
Ignition switch is OFF: TAIL
indicator light is off
Normal data is
received
Condition
Fail-safe Operation
Fail-safe
Deactivation
Condition
While ignition switch is ON, tire
pressure warning signals are
interrupted
Ignition switch is ON: Tire pressure
warning light blinks for 60 to 64
seconds
Ignition switch is OFF: Tire pressure
warning light is off
Normal data is
received
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
A/T OIL TEMP WARNING LIGHT FAIL-SAFE CHART
CHARGE warning light:
CHARGE WARNING LIGHT FAIL-SAFE CHART
OIL PRESSURE warning light:
OIL PRESSURE WARNING LIGHT FAIL-SAFE CHART
4LO indicator light:
4LO INDICATOR LIGHT FAIL-SAFE CHART
WASHER warning light:
WASHER WARNING LIGHT FAIL-SAFE CHART
AUTO LSD indicator light:
AUTO LSD INDICATOR LIGHT FAIL-SAFE CHART
Condition
Fail-safe Operation
Fail-safe Deactivation
Condition
While ignition switch is ON, A/T OIL
TEMP warning signals are interrupted
Display condition is maintained
until ignition switch OFF
Normal data is received
Condition
Fail-safe Operation
Fail-safe Deactivation
Condition
While ignition switch is ON, CHARGE
warning signals are interrupted
Display condition is maintained
until ignition switch OFF
Normal data is received
Condition
Fail-safe Operation
Fail-safe Deactivation
Condition
While ignition switch is ON, OIL PRESSURE
warning light request signals are interrupted
Display condition is maintained
until ignition switch OFF
Normal data is
received
Condition
Fail-safe Operation
Fail-safe Deactivation
Condition
While ignition switch is ON, frame (including
B INDL 4 bit) is interrupted for 3 seconds
Display condition is maintained
until ignition switch OFF
Normal data is
received
Condition
Fail-safe Operation
Fail-safe Deactivation
Condition
While ignition switch is ON, washer fluid
level low signals are interrupted
Display condition is maintained
until ignition switch OFF
Normal data is received
Condition
Fail-safe Operation
Fail-safe Deactivation
Condition
While ignition switch is ON, frame
(including B ALSD bit) is interrupted
Display condition is maintained
until ignition switch OFF
Normal data is received
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
VSC OFF indicator light:
VSC OFF INDICATOR LIGHT FAIL-SAFE CHART
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and
other items to be read without removing any parts. This non-intrusive inspection can be very useful
because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading
the Data List information early in troubleshooting is one way to save diagnostic time.
a. Connect Techstream to the DLC3.
b. Turn the ignition switch ON.
c. Turn the tester ON.
d. Enter the following menus:
Techstream - Select: Body Electrical, Powertrain or Chassis / (desired system) / Data List.
e. According to the display on tester, read the "DATA LIST" or "Data List".
Techstream
Combination Meter:
TECHSTREAM COMBINATION METER RANGE REFERENCE
Condition
Fail-safe Operation
Fail-safe Deactivation
Condition
While ignition switch is ON, frame (including
B TRCW bit) is interrupted for 0.9 seconds
Display condition is maintained
until ignition switch OFF
Normal data is
received
NOTE:
In the table below, the values listed under "Normal Condition" are
reference values. Do not depend solely on these reference values when
deciding whether a part is faulty or not.
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Tail Cancel SW*
TAIL cancel switch
condition/ON or OFF
ON: TAIL cancel
switch ON
OFF: TAIL cancel
switch OFF
-
ODO/TRIP Change
SW
Trip switch (ODO/TRIP
switch) condition/ON or
OFF
ON: Trip switch
(ODO/TRIP switch)
pushed
OFF: Trip switch
-
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
(ODO/TRIP switch)
not pushed
Vehicle Speed
Meter
Vehicle speed/Min.: 0 (0),
Max.: 255(158)
Almost same as
actual vehicle speed
(when driving)
Unit: km/h (mph)
Engine Rpm
Engine speed/Min.: 0, Max.:
12750
Idling: 700 to 800
Unit: rpm
Coolant
Temperature
Engine coolant temperature/
Min.: -40 (-40), Max.: 140
(284)
After warming up: 80
to 105 (176 to 221)
Unit: °C (°F)
If value -40
(-40): sensor
circuit open
If value 140
(284): sensor
circuit
shorted
Washer Switch
Washer switch/ON or OFF
ON: Washer switch
ON
OFF: Washer switch
OFF
-
+B Voltage Value
+B voltage/Min.: 0, Max.:
25.5
Below 1 to 14
Unit: V
Integrated value for
Oil Maintenance
Integrated value for oil
maintenance warning/Min.:
0 (0), Max.: 25500 (41037)
0(0) to 25500 (41037) Unit: mile (km)
Fuel Input
Fuel sender gauge
input/Min.: 0, Max.: 127.5
Fuel sender input
value
Unit: L
Rheostat value
Light control rheostat switch
input/Min.: 0, Max.: 100
Light control rheostat
switch is Dark (0) -->
Bright (100)
Unit: %
Quantity of Outside
Light
Outside dimmer
output/Min.: 0, Max.: 100
0 to 100
Unit: %
Communication
ECM/Meter DTC 3
ECM communication stop
history/Rec or Unrec
Rec: DTC is recorded
Unrec: DTC is not
recorded
-
ECM ODO
(History 3)
ECM odometer
history/Min.: 0, Max.:
999999
With history: 0 to
999999 Without
history: ffffffh
-
Communication
ECM/Meter DTC 2
ECM communication stop
history/Rec or Unrec
Rec: DTC is recorded
Unrec: DTC is not
recorded
-
ECM ODO
(History 2)
ECM odometer
history/Min.: 0, Max.:
999999
With history: 0 to
999999 Without
history: ffffffh
-
Communication ECM communication stop
Rec: DTC is recorded
Unrec: DTC is not
-
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст