Toyota Tundra. Manual — part 2205

Fig. 63: Reaming Guide Bush
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

3. REPLACE RING PIN

a. Remove the ring pins.

b. Using a plastic-faced hammer, tap in new ring pins to the cylinder head.

NOTE:

It is not necessary to remove the ring pin unless it is being replaced.

2009 Toyota Tundra

2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra

Fig. 64: Locating Cylinder Head Ring Pins
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Standard protrusion

STANDARD PROTRUSION SPECIFICATION

REASSEMBLY

1. INSTALL STUD BOLT

a. Using E7 and E8 "TORX" socket wrenches, install the stud bolts.

Torque: for stud bolts A, B, C, D

9.0 N*m (92 kgf*cm, 80 in.*lbf)

Item

Specified Condition

Ring pin A 5.5 to 6.5 mm (0.217 to 0.256 in.)

Ring pin B 3.5 to 6.5 mm (0.138 to 0.256 in.)

2009 Toyota Tundra

2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra

Fig. 65: Locating Cylinder Head Stud Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2. INSTALL NO. 2 STRAIGHT SCREW PLUG

a. Using a 14 mm hexagon wrench, install 2 new gaskets and the 2 straight screw plugs.

Torque: 85 N*m (867 kgf*cm, 63 ft.*lbf)

Fig. 66: Locating No. 2 Straight Screw Plug
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2009 Toyota Tundra

2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra

3. INSTALL NO. 1 STRAIGHT SCREW PLUG

a. Using a 10 mm hexagon wrench, install 6 new gaskets and the 6 straight screw plugs.

Torque: 44 N*m (449 kgf*cm, 32 ft.*lbf)

Fig. 67: Locating No. 1 Straight Screw Plug
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

4. INSTALL VALVE SPRING SEAT

a. Install the valve spring seats to the cylinder head.

5. INSTALL VALVE STEM OIL SEAL

a. Apply a light coat of engine oil to new oil seals.

NOTE:

Pay attention when installing the intake and exhaust oil seals. For
example, installing the intake oil seal into the exhaust side or
installing the exhaust oil seal into the intake side can cause
installation problems later.

2009 Toyota Tundra

2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra